Using The Remote; Changing Button Assignments - Sony HT-DDW3000 Operating Instructions Manual

Using the Remote

Changing button
assignments
You can change the factory settings of the
input buttons to suit the components in your
system. For example, if you connect a DVD
player to the SAT jacks on the receiver, you
can set the SAT button on this remote to
control the DVD player.
1
Hold down the input button of
which you want to change the
assignment.
Example: Hold down SAT.
2
Referring to the table below,
press the corresponding
button for the category you
want.
Example: Press 3.
Now you can use the SAT button to
control the DVD player.
Categories and the
corresponding buttons
Categories
VCR (command mode VTR 3)
VCR (command mode VTR 2)
DVD player/DVD recorder
(command mode DVD1)
DVD recorder
(command mode DVD3)
CD player
Euro Digital Satellite Receiver
DVR (Digital CATV terminal)
DSS (Digital Satellite Receiver) 8
Blu-ray disc player
(command mode BD1)
Blu-ray disc recorder
(command mode BD3)
TV
Not assigned
a)
Sony VCRs are operated with a VTR 2 or VTR 3
setting which corresponds to 8 mm and VHS
respectively.
b)
Sony DVD recorders are operated with a DVD1 or
DVD3 setting. For details, refer to the operating
instructions supplied with the DVD recorders.
c)
For details on the BD1 or BD3 setting, refer to
operating instructions supplied with the Blu-ray
disc player or Blu-ray disc recorder.
To clear all remote button
assignments
Press ?/1, TV INPUT and MASTER VOL – at
the same time.
The remote is reset to its factory settings.
Press
a)
1
a)
2
3
b)
4
b)
5
6
7
9
c)
0/10
c)
-/--
ENTER/
MEMORY
49 GB