Playback On Tv Without; Audio/Video Inputs - RCA CC618 User Manual

ilii ii i ii:¸:¸¸i _ i i i: ilil_iiiiiiiiiiiii_i_i_i i iiiiii[ii_iiiiiiiiiiiiiii _ iiiiiiiiiii::_ii _iii _ _i!iiiiiiiiiiiiii_iiiiiiiiiiiiiiiii_iiiiiii _ iiiiiiiiiii_iiiiiiiiiiii_i:iiiiiiiiii _i_i_i_iiiiiiiiiiiiiiii:iiiiiiiiiiiiiiii_:_:i_: iiiiiiili_ iiiiiii i_i_:_i_i iiii::: _]iiiiiiiiiii i_iii_i iiiii_i_i "iiii!i!iiii_iiiiiiiiiii _¸_¸¸¸_iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii!iiiiiiiiiiiiiiiii_ _: iiiiiiiiiiii_iiiiiiiiiii!iiiiiii_iiiiiiiiiii_: iiiiiiiiiiiiiii_ iiii i iiiiiiiii!_iiiiiiiii_i_:: _i i li
Playback on a TV Without Audio/Video Inputs
To connect your camcorder to a TV without audio/video inputs, you will need an
optional 1CVA147C RF output adapter and an optional coaxial RF cable, such as
AH065G or AH066G shown on page 72. If your TV has AUDIO and VIDEO IN jacks
(or is connected to a VCR), refer topages 66-67.
VHF Antenna
• R I
Optional
Transformer
{Such as 193983)
Optional Coaxial
RF Cable
(such as AH065G or AH066G)
Back of TV
i / o.t.
' Optin ,' rr r
\
AUDIO, RE DC
OUT, VIDEO Jacks
RF Output
Adapter's Plug
IN FROM ANT
Connector
CH3/CH4 Switch
Optional RF Output Adapter
(ICVAI47C)
Installation
(_ Disconnect the VHF from
antenna
your TV. Connect the antenna to the
INFROMANT connector on the RF
output adapter if you are going to leave
the adapter connected to the TV.
Note: If your VHF antenna is the flat
twin-lead type attached by two screws,
you will also need an optional 300/75 ohm
transformer, such as 193983 shown on
page 72.
(_)Attach one end of the optional coaxial
RF cable to the OUT TO TV connector
on the adapter, and attach the other end
to the VHF input on your TV as
shown.
Note: If your TV has 300 ohm screw
terminals, you will need a 75/300 ohm
transformer, such as AH011, shown on
page 72.
(_ Attach the RF output adapter's plug to
the AUDIO, RF DC OUT, and VIDEO
jacks located under the small cover on
the back of the camcorder.
68