Table of Contents
Advertisement
Using the Battery to Power Your Camcorder
The battery must be charged as described
on the nextpage
before it can be used the
first time.
Initial charging
will take approximately
70 minutes.
When fully charged,
the battery should supply about 60 minutes
of operating
time (depending
on how much
you use the light, zoom, and pause).
Conserve
battery power by turning the camcorder
off during recording
breaks.
Note: The small marker switch on top of the battery is for use as a personal reminder to help
you remember to recharge the battery. It has no other function.
Reference Marks
Marker
Switch
BA TT. RELEASE
Button
Attach
the Charged
Battery
If the power connector is attached
to the
camcorder,
remove it before attaching
the
battery.
Also, install the lithium clock
cell before attaching
the battery pack.
Details on page 52.
1. Align the reference mark on the battery
with mark on back of camcorder.
2. Hold the top of the battery flush against
the camcorder
and press the bottom of
the battery down until it locks into
place.
3. Place the POWER
switch in CAMERA.
The power indicator
will light.
Remove the Battery
Press and hold BATT. RELEASE on the
camcorder while removing the battery.
ATTENTION:
NICKEL CADMIUM BATFERY MUST BE DISPOSED OF
PROPERLY.
THE PRODUCT THAT YOU HAVE PURCHASED USES A
RECHARGEABLE
BATI'ERY.
AT THE END OF ITS USEFUL LIFE,
UNDER VARIOUS STATE AND LOCAL LAWS, IT MAY BE ILLEGAL TO
DISPOSE OF THIS BAqTERY INTO THE MUNICIPAL
WASTE STREAM.
CHECK WITH YOUR LOCAL SOLID WASTE OFFICIALS FOR DETAILS
IN YOUR AREA FOR RECYCLING OPTIONS OR PROPER DISPOSAL.
Ni - Cd
13
Advertisement
Table of Contents
