Table of Contents
Advertisement
Other [ formation
Troubleshooting
Most problems you encounter
with your IV can be corrected by consulting
the following
troubleshooting
list.
Note: If you prefer, we con p_ovideyou w;th the nameof an Authorized Serv;ceRepresentot;_,e who will visit your home for a t_et_ ;nst_fl your electronic ent_rtoinm_nt system
arid to instruct you ;rl its operation. Furd_,t_;Isabout th;s serviee,earl 1 888_206_3359.
TV Problems
]V
won't
turn
on
Press the IV button,
Make sure the TV is plugged in,
Check the walt receptacle (or extension cord) to make sure it is "live" by plugging in something else,
Something might be wrong with your remote control, Press the POWERbutton on the front of the W, If the TV turns on, cheek the remote control
solutions on page 27,
The front panel controls may be locked (disabled), Use the remote control to unlock the front panel controls by selecting the Front Ponet Block in the
Parental Control menu and press OK to uneheek the box,
Buttons
don't
work
=
If you're using the remote control, press the IV button first to make sure the remote is in IV mode,
The front panel controls may be locked (disabled), Use the remote control to unlock the front panel controls by selecting the Front Ponet Block in the
Parental Control menu and press OK to uneheek the box,
Unplug the 1V for two minutes and then plug it back in, Turn the IV on and try again,
T¢ turns
off while
playing
Sleep timer may have been activated, Go to page 24 for instructions,
Electronic protection circuit may have been activated because of a power surge, Wait 30 seconds and then turn on again, If this happens frequently, the
voltage in your house may be abnormally high or low.
Unplug, Wait five minutes, Plug in again,
T¢ turns
on
unexpectedly
Wake up timer might have been activated, Go to page 24 for instructions,
Auto on might have been activated, Go to page 24 for instructions,
You might have pressed CH+, CH- or INPUT on the remote accidentally.
Blank
screen
Make sure the component connected to the IV is turned on,
Try another ehannek
No sound,
picture
okay
Maybe the sound is muted, Try pressing the volume Lip button to restore sound,
If using S-Video or Y, PB, P _,remember to also connect the component's left and right audio output jacks to the IVs t]MONO and R Audio Input jacks,
Make sure the [NTIEXTswitch on the back of the IV is put on "INT".
The sound settings may not be set correctly. Go to page 22 for more information,
Can't
select certain
channel
Channel may be blocked or not approved in the Parental Controls menu,
_f using a _CR_eheek t_ make sure the TV_VCRbutt_n _n the _CR is in th_ __rreet m_d_ (press the TV_VCRbutt_n _n y_ur _CR__
Noisy stereo
reception
May be a weak station. Use Sound menu to choose mono sound,
No picture/blue
screen,
no sound
butW
is on
Maybe the eabietair function
is set to the wrong position, Go to page 24 for detailed instructions,
The channel might be blank-
change channels,
If you're watching your VCR and it's connected with coaxial cable to the CABLE]ANTENNAjack, tune the IV to channel 3 or 4 (whichever channel is
selected on the 314 switch on the back of your VCR), Also check to make sure the IV/VCR button on the VCR is in the correct mode (press the IVjVCR
button on your VCR),
26
Graphics contained
within this publication
are for representation
only.
Cha_teF
5
Advertisement
Table of Contents
