NEC 4400 - SuperScript Color Laser Printer User Manual page 84

Unit Status: Click here to view the current state for each
protocol and NIC port available on your NIC. For each
supported protocol (Novell NetWare, TCP/IP, or
AppleTalk), the top line displays the protocols supported
and if the protocol is enabled or disabled.
Network Address: Click here to view the serial number
and the Ethernet MAC (Media Access Control) address
for the 4400N.
Change Password: Changing any parameters using the
Network Administration Page requires a password. Click
here to change your password. The default password is
sysadm. Your password can contain letters, numbers, and
punctuation, and is case sensitive.
note:
If you forget your password, you can restore
factory defaults manually. See page 74.
Protocol Functions
The Protocols feature is for setting up network options and
parameters. It provides extensive access to NIC parameters,
and allows you to setup IP parameters (IP address, subnet
mask, and default gateway). You can enable/disable
AppleTalk and NetWare, but not TCP/IP. (We recommend
that you disable any protocol that you are not using.)
76 SuperScript 4400 Series — User's Guide
Other Functions
Test Printer: Click here, and then click on the Start Test
button in the dialog box that appears, to send a test
document to the printer.
Configure Status Page: Click here to configure
Network Settings page options. In the dialog box that
appears, select the checkbox by Print Status Page on
Startup to generate a status page (the Network Settings
page) each time you turn on the printer or reset the NIC.
note:
We recommend that you leave this setting
checked to print at power-on.
To print out a Network Settings page immediately, click
Generate Now.
Printer Status: Click here to display status information
for the printer and NIC, as well as errors and messages.