Drying - Electrolux EDI 96150 User Manual

Problem
Drying results unsatisfac-
tory.
When you press a button
Err appears in the multi-
display.
Drying cycle ends shortly
after programme starts.
ANTICREASE display illu-
minated.
Programme inactive,
CONTAINER display illu-
minated.
PROGRAMME TIME dis-
play changes erratically or
stays unchanged for a
long time.
Drying cycle lasts an unu-
sually long time.
Note: After up to 5 hours
the drying cycle ends au-
tomatically
(see 'End of drying cy-
cle').
Discoloration
Possible cause
Wrong programme selected.
Lint filter blocked.
Heat exchanger blocked with
fluff.
Incorrect amount of washing.
Ventilation slots in base area
covered up.
Residue on inside surface of
drum or drum paddles.
Laundry guard. Additional func-
tions cannot be selected after a
programme has started.
Too little laundry has been load-
ed for the selected programme,
or laundry that is too dry.
Condensed water container is
full.
Programme time is corrected
automatically depending on
type and volume of laundry and
level of dampness.
Fluff filter blocked.
Heat exchanger blocked with
fluff.
DELICATE button pressed and
load volume too big.
Load volume too big.
Laundry insufficiently pre-
drained.
Colour fastness of textiles.
what to do if... electrolux 37
Remedy
Select a different programme the
next time you dry (see section
"Overview of programmes").
Clean lint filter.
Clean heat exchanger.
Observe recommended loads.
Uncover ventilation slots in base
area.
Clean inside surface of drum and
drum paddles.
Adjust using the DRYNESS addi-
tional function (see chapter on
'Drying, selecting additional func-
tions').
Turn the programme knob to
O
OFF. Reset programme.
Select time programme or higher
drying level (e.g. EXTRA DRY
instead of STORAGE DRY).
Empty condensed water contain-
er, then start programme with the
[START/PAUSE] button.
Automatic process, there is no
fault with the appliance.
Clean fluff filter.
Clean heat exchanger.
DELICATE is only suitable for use
with loads of up to 3kg!
Reduce load volume.
Laundry must be adequately pre-
drained.
Check colour fastness of textiles.
Only treat textiles together if they
are a similar colour.