The appliance does not operate
•
The appliance may not be plugged into the wall socket.
•
The wall socket may be switched off.
Filter indicator lights up and stays on
•
The dust container is full. Empty the dust container and check the filters.
•
The filters are clogged. Clean or replace the filters.
Loss of suction
•
The hose, extension tubes or accessories may be blocked.
Switch the cleaner off and unplug it from the wall socket.
Remove the blockage.
• The Filters may be clogged. Clean or replace filters.
•
The dust container is full. Empty the dust container and clean or replace
the filters.
Cleaner switches off during operation.
Note: The motor is fitted with a thermal cut-out switch which will
automatically switch off the cleaner if the motor starts to overheat.
Should this happen please do the following:
•
Switch the cleaner off by pressing the on\off switch pedal and unplug
it from the wall socket.
•
Allow the cleaner to cool down for approximately 40 minutes.
•
During this period, check for blockages in the hose, extension tubes and
accessories. Check if the dust container is full or if the filters are clogged.
•
Once the cleaner has cooled down, the thermal cut-out switch resets
and the cleaner will be ready for use again.
Should the cleaner fail to operate, please contact your nearest authorized
Electrolux service center.
TROUBLE SHOOTING
10