Operating The Cleaner - Electrolux Z1660 Owner's Handbook Manual

Unpack the appliance and remove all the packaging materials.
Carefully study the safety instructions listed in the Important User
Information.
Caution: Always ensure that the cleaner is unplugged from the wall
socket before fitting or removing accessories.
Never operate the cleaner without the filters in place or with dirty
and clogged filters.
Do not operate the cleaner with wet hands.
1. Insert the hose end into the air intake duct and push until the catch clicks
into position. To remove the hose press the catch release button and pull
hose end out of the intake duct.
2. Attach the extension tube to the hose handle and the desired floor nozzle
to the other end of the extension tube. To remove the extension tube or
the accessory twist and pull apart.
Note: On model Z1660 (with telescopic extension
tubes) the length of the extension tubes can be
adjusted by pressing down on the release button
on the outer tube and sliding the inner tube.
3 Pull the required length of electrical cord out of the cleaner and connect
the plug to the wall socket.
Note: The yellow mark on the electrical cord indicates the maximum
length of usable cord. Never unwind the electrical cord beyond the red
mark.
4. Press the on/off foot pedal to switch the cleaner on.
5. The suction power can be adjusted by opening or closing the aperture
on the hose handle.
BEFORE USING THE CLEANER

OPERATING THE CLEANER

5