Advertisement
Components and Maintenance
Applies to certain models only
Electrical cable Features
Power On and Adjustment
Recommended nozzle usage
Recommended nozzle
Attaching after use
Care and Cleaning
Safety precautions
Thank you for choosing an Electrolux Vacuum Cleaner.
Read all instructions and use the appliance only for its intended purpose. This vacuum cleaner is for household use only.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. The vacuum cleaner features double insulation and does not need to be earthed.
Children should be supervised to ensure that they do not play with the appliance.
Never vacuum
- In wet areas.
- Close to flammable gases, combustible substances, etc.
- Without a cartridge filter (this maydamage the cleaner) and without the dust container. A safety device is fitted which prevents the cover to close without the filter. Do not attempt to force to close the cover.
- Sharp objects.
- Fluids (this can cause serious damage to the machine).
- Hot or cold cinders, lit cigarette butts, etc.
- Fine dust including powder detergents, dust from plaster, concrete, or ash for example. The above can cause serious damage to the motor – damage which is not covered by the warranty. Products in aerosol or near the vacuum cleaner.
Electrical cable precautions
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly to the cleaner cable will not be covered by the warranty.
- Never pull or lift the vacuum cleaner by the cable.
- Disconnect the plug from the wall socket before cleaning or maintaining the vacuum cleaner.
- Regularly check that the cable is not damaged. Never use the vacuum cleaner if the cable is damaged. All service and repairs must be carried out by an authorized Service centre. Always keep the vacuum cleaner in a dry place.
Troubleshooting
You can perform your own troubleshooting at home based on the checklist given below.
However, if the problem persists, please consult your nearest authorized Electrolux Service Centre.
| PROBLEM | POSSIBLE CAUSES | CORRECTIONS |
| The vacuum cleaner does not start. | The plug is not properly connected to the socket. | Check the plug connection or try another socket. |
| Thermal protector activated due to the motor to cool off. | Press the ON/OFF button and wait 20 – 30 minutes for high temperature. | |
| Filter indicator* lights and stays on. | Dust container is full. | Empty the dust container. |
| The filters are clogged. | Clean or replace filters. | |
| Reduction of suction capacity. | Suction hose is blocked. | Clean the hose. |
| Nozzle is blocked. | Clean the nozzle. | |
| Dust container is full. | Empty/replace the dust container. | |
| Filters are clogged. | Clean or replace filters. | |
| Hose is damaged or broken. | Change the hose. | |
| Dust container is not in place. | Put dust container in place. | |
| Filter is not in place. | Put dust container in place. | |
| Over heating. | Dust container is full. | Empty/replace the dust container. |
| Filters are clogged. | Clean/replace filters. |
* Applies to certain models only
Website: www.electrolux.com
Documents / Resources
References
Download manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Electrolux CompactGo Cyclonic - Vacuum Cleaner Manual
Advertisement
Need help?
Do you have a question about the CompactGo Cyclonic and is the answer not in the manual?
Questions and answers