Eiki DLP EIP-4200 Owner's Manual page 19

Table of Contents

Advertisement

4. Adjust the projected image
1
Adjusting the focus.
2
Adjusting the height.
3
Adjusting the picture size.
5. Correct trapezoidal distortion
Correcting trapezoidal distortion using Keystone Correction.
On the projector
On the remote control
6. Select the INPUT mode
Select the "COMPUTER" using INPUT on the projector or COMPUTER on the remote
control.
On the
On the remote
projector
control
When you press INPUT on the projector, the INPUT list appears.
Press '/" to switch the INPUT mode.
7. Turn the computer on
8. Turn the power off
Press STANDBY/ON on the projector or STANDBY on the remote control, and then press
the button again while the confi rmation message is displayed to put the projector into
standby mode.
On the
projector
Shrinks
upper side.
INPUT list
INPUT
COMPUTER
DVI-D Computer
D
DVI-D Video
D
On the remote
control
On-screen display (RGB)
COMPUTER
RGB
1024 × 768
On-screen display
_P. 27
Shrinks
lower side.
_P. 28
_P. 29
_P. 26
17

Advertisement

Table of Contents
loading

Table of Contents