Table of Contents
Advertisement
Installation
There are two ways you can quickly setup the Wi-Fi extender - using
browser-based iQ Setup (steps 1 - 15 below) or using the WPS button (see
WPS Setup).
Note:
close to your router/access point for the setup process.
You need to establish a connection between your
extender and router/access point. After setup is
complete and a connection is established, you can
move the extender to your preferred location.
Note:
make sure your computer is set to use a dynamic IP
address. This is a simple procedure, and step by step
instructions for how to do this can be found in the user
manual.
1.
Plug the Wi-Fi extender into a power outlet close to the root wireless
access point and switch it on. The power LED (
extender initializes – please wait. The extender is ready when the power
LED is on.
2.
You can connect to the Wi-Fi extender using a (i.) wired or (ii.) wireless
connection.
Note:
may have, and/or disconnect/disable any other
Ethernet cables/adapters from your computer.
It is recommended that you plug in the extender
Before you use the wireless extender, please
Please disable any other Wi-Fi adapters you
) will flash while the
3
Advertisement
Table of Contents
