Assembly - Troy-Bilt 1902 Owner's Manual

Section 3: Assembly
_mmm
ue
4. Insert other"L" hook through hole just above billboard
on right side of handte (viewing from rear of unit),
Hold hook in place with a pliers and attach Iocknut
with a 7/16" wrench (Figure 3).
Add Engine Oil and Fuel
• Place pressure WaSher on a level surface.
• Refer to engine owner's manuat and follow oil and fuel
recommendations and instructions.
CAUTION
• Refer to engine manua_ foroH and rue{ fill information,
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
NOTE: Check oil often during engine break-in. Refer to
engine owner's manua{ for recommendations.
Connect Hose and Water Supply to
Pump
IMPORTANT: To avoidpump damage, yOU must assemble
the nozzle extension to the spray gun and a_tach a!l hoses
before y0u start the enginel
Attach 0no end of high pressure hose tO high pressure
0udet 0n pump (Figure 4).Tighten by
j-
!-
C
2, Attach other end of hose to base of spraygun
(Figure 5),Tigh_n by hand.
-Connect High
Pressure Hose
Here