Sherwood RD-6108 Owner's Manual page 20

Select the desired preset number (1~30) and
press the MEMORY/ENTER button.
• TUNING/PRESET • MEMO/EN_
• When using the NUMERIC buttons on the remote
control.
Examples) For "3":
1 wiNin 2 seconds 5
For "15" : @_ O
For "30": 6)
• The station has now been stored in the memory.
• When using the NUMERIC buttons, the station is
stored autolnatically without pressing the
MEMORY/ENTER button.
• A stored frequency is erased from the memo U by
storing another frequency in its place.
• If "MEM" goes off, start again from the above step 2.
Repeat the above steps 1 to 3 to memorize
other stations.
• MEMORY BACKI P FUNCTION
The following items, set before the receiver is turned
Tuning to preset stations
After selecting the tuner as an input
source, select the preset tuning mode.
off, m'e memorized.
• INPUT SELECTOR settings
• Surround mode settings
• Preset stations,etc.
Note : If the electricity fails or the AC input cord is
disconnected for more than 2 weeks, they are all
T/P MODE
• Then "PRESET" lights up.
Listening to FM stereo broadcasts
• While listening to FM broadcasts.
• Each time this button is pressed,
the FM mode changes as t_llows;
V_ Stereo mode : "ST" lights up.
q
Mono mode : "ST" goes off. <_
FM MODE
• When FM stereo broadcasts are poor because of
weak broadcast signals, select the FM mono mode to
reduce the noise, then FM broadcasts are reproduced
in monaural sound.
cleared. So you should memorize them again.
Select the desired
preset number.
• When using the NUMERIC buttons on the remote
control.
3
Examples) For"3": .._,
q withr_2 seconds 5
For "15": @,._" " _ _CD_* ",
o s wit/in 2 seconds o
For "30": O,/or ,CD)_ , _ _,)
• When selecting the desired preset number with the
NUMERIC buttons, the desired preset station will be
tuned to automatically without selecting the preset
tuning mode.
Scanning preset stations in sequence
• The receiver will start sc_ning the stations in the preset
sequence mid each station is received t_r 5 seconds.
• At the desired station, press this button again to stop
scanning.