Sherwood RD-6108 Owner's Manual page 18

In Dolby Digital, Dolby Pro Logic 11, D olby
Pro Logic or Dolby Virtual mode, adjusting
delay times of the speakers
• In case of Dolby Digital, Dolby Pro Logic II o1"Dolby
l:h'oLogic mode, when the distances from the prime
listening position to fl'ont left, center, front right, rem"
left and rear fight speakers m'e same, the basic settings
are as follows according to the SmTound modes;
In tile Dolby Digital mode,
Center delay trine : 0 ms, Rear delay time :0 ms
In the Dolby Pro Logic II Music, Matrix or Custom mode,
Rear delay time : 0 ms
In tile Dolby Pro Logic II Movie, Dolby Pro Logic mode,
Rear delay time : 10 ms
• If the center or the rem"speaker(s) is(re'e) not at the
same distance from the prime listening position as the
front speakers, increase or decrease the center delay
time by 1 ms tbr every about 30 cm(1 foot) it is closer
or farther away and increase or decrease the rear delay
time by 5 ms for eve_2¢about 1~1.5 m(3~5 feet) it is
closer o1" farther away.
Check the delay" time
to be adjusted.
• The delay time will be displayed for 5 seconds.
• The con'esponding delay time is displayed. The
center delay time can be adjusted in the Dolby
Digital mode only.
• In the Dolby Virtual mode, "NARROW" or
"WIDE" is displayed.
Adjust the delay time.
Each time this button is pressed in the Dolby
Digital, Dolby Pro Logic II or Dolby Pro Logic
mode, the delay time changes in regular intervals.
Each time this button is pressed in the Dolby Virtual
mode, the delay mode changes as tbllows:
NARROW: Relatively lon e distance from the
l prime listening position to front
] speakers.
WILDE:Relatively short distance.
• If the delay time disappears, start from the step 17
again.
In Dolby Digital mode, repeat the above
steps 17 and 18 to adjust the rear delay
time.
Downmixing into 2 front channels
• Allows the multi-channel DTS or Dolby Digital signals
to be reproduced through only two speakers or through
headphones.
• When the digital signals fi'om the DTS or Dolby Digital
program sources are input in available smTound mode,
press the STEREO button.
STeReO
©
• "ST" and the DTS or Dolby Digital indicators light up,
meaning it enters the 2-CH dowmnix mode, and then the
discrete mnlti-channels(except LFE) are mixed down into
2 front channels.
To cancel the 2-CH downmix mode, select the
desired surround mode with using the DSP MODE
button.
When the playback of the source on the player is
stopped or inten'upted, etc., the 2-CH downmix
mode is not canceled even though "ST" and the
DTS or Dolby Digital indicators go off.
If the headphones are plugged and the SPEAKER
button is set to off while the digital signals ti"om the
DTS and Dolby Digital program sources are being
input, it will enter the 2-CH downmix mode
automatically(but only the DTS or Dolby Digital
indicator lights up still) and if the headphones are
unplugged and the SPEAKER button is set to on in
the 2-CH downmix mode, it will return to the
previous mode.