Sherwood RD-6108 Owner's Manual page 17

RD-6108(A) 2003.3.4 3:54 PM _t101X117
Adjusting each channel level
Select the desired channel.
• Each time this button is pressed, the corresponding
channel is selected and displayed tbr 3 seconds as
follows;
[_ Front Left _ Center _ Front Right _ Rear Right
(Dolby Digital or DTS LIFE) _)SubWoofer _ Rear Left
( ): Adjustable only when the digital signals flmn Dotby Digital or
DTS program somce that includcs LFE signal are input in the
available surround mode
• When it is in the stereo or Dolby Virtual mode, or
the speaker setting is "N", center, rein" or subwoofer
channel will not be selected.
Adjusting each channel level with
test tone
• Only"when it is in available sm'round modes except
the Dolby Virtual and stereo modes, the volume
level of each channel can be adjusted easily with the
test tone function.
mNote: When the 6 CH DIRECT is selected as an input
som'ce, the test tone function does not work.
Enter the test tone mode.
\ /
• The test tone will be heard fl'om the speaker of each
channel for 2 seconds as follows;
c Front Left _ Center --+ Front Right
SUBwoofer _--Rear Left _- Rear Right
• o
When the speaker setti% is "N", the test tone of the
con'esponding channel is not available.
• When the selected decoding mode is not matched to the
input signal format, the test tone function cannot work.
Adjust the level of the selected channel
as desired.
d ......
The LFE level can be ad usted within the range of
-10~0 dB and other channel levels within the range
of-15~+15 dB.
In general, we recommend the LFE level to be
adjusted to 0 dB. (However, the recommend LFE
level for some early DTS software is -10 dB.) If the
recommended levels seems too high, lower the
setting as necessary.
If the channel display disappears, start fi'Oln the
above step 11 again.
Repeat the above steps 11 and 12 to
adjust other channel levels.
At each channel, adjust the level as desired
until the sound level of each speaker is
heard to be equally loud.
or
• You can select the desired channel and adjust its
level with repeating the steps 11 and 12 in
"Adjusting each channel level" procedure.
Cancel the test tone function.
!/