Sherwood RD-6108 Owner's Manual page 16

RD-6108(A) 2003.3.4 3:54 PM _4101XI16
At the desired parameter,
adjust it as desired.
• If the pm'ameter display disappears, start from the
step 3 again.
Adjusting the speaker settings
• Adjust the settings of front, center ,rear speakers and
subwoofer connected.
• If the speaker setting is adjusted to "S", the low range
bass sound of the channel(s) is redirected to the
subwoofer or the front channels and if the speaker
setting is adjusted to "N", the sound of the channel(s)
Repeat the above steps 3 and 4 to adjust
other parameters.
mNote:
• In the Dolby Pro Logic II Customer mode, you cannot set both of
the 7 kHz Low Pass Filter and Shelf Filter to ON sinmltan¢ously.
If so, the fitter set previously is automatically changed to OFF.
Select the desired speaker
setting.
• Each time this button is pressed, one of 11 different
speaker settings is selected and displayed for 8
seconds as follows;
is redirected to other channels.
Press the SPEAKER
MODE button for more
than 2 seconds to enter the
front-center-rear speaker
mode.
SPEAKER
MODE
FL CS RS, FL<TL RS, FL CL RL,
FL -CL-RN, FL-CS -RL, FL -£:N -RL,
FL CS RN, FL CN RS, FS_2S RS,
FS-CS-RN and FS -CN -RS
• In the displays, F stands tbr Front, C tbr Center, R
tbr Rear, L for Large, S for Small and N tbr None.
• When judging whether a speaker is Large or Small,
• The fi'ont-center-rem" speaker setting is displayed.
• When the SPEAKER button is set to off or the 6 CH
DIRECT is selected as ml input som'ce, the speaker
mode function cannot be available.
• When it is in the stereo or Dolby Virtual mode, only
the subwoofer setting can be adjusted.
Memorize the desired
MEMO/ENTER
speaker setting
while it is displayed.
• The desired speaker setting is memorized and then
it enters the subwoofer mode.
• If the speaker setting display disappears, start from
the above step 6 again.
Memorize the subwoofer
MEMO/ENTER
setting while it is
displayed.
• If the subwoofer setting display disappears, start
from the _above step 6 a_ain.,_
please note that a standard large speaker can fnlly
reproduce sounds below 80 Hz.
The following speaker settings cannot be selected.
Front :Small, Center : Large and Rear : Large(FS-
CL-RL) or Center : None and Rear : None(CN-RN)
setting.
Select the desired
subwoofer setting.
Checking the speaker setting
SPEAKER
MOOE
CCC_
• Each time this button is pressed briefly, the fi'ont-
center-rear speaker or subwoofer setting is displayed.
• Each time this button is pressed, the subwoofer setting
changes and is displayed for 8 seconds as follows;
BB W(oofer) Y(es): When using a subwoofer
W(oofer) N(o) : When not using a subwoofer
• In case that the front speaker is set to "S", the
subwoofer is automatically set to "Y".