Table of Contents
Advertisement
Playback
Before
Starting
Playback
1
Hold in the tab on the battery
cover
and pull the
cover
towards
the direction
of the arrow.
2
3
J7
dd. ¢Y
Load the two "AAA"
size batteries
(R-03 size,
UM/SUM-4).
Place batteries
with their terminals
corresponding
to the (+} and (}
indications
in
battery
compartment.
Insert the smaller
tab of the battery
cover
into
the opening
(_), and press down
on the cover
until it clicks
in place
(_).
Remote corltro[ sensor
Approx. 22 feet (7 m)
4 Remote control unit
Plug the supplied
AC cord into the AC IN terminal
on
the rear of the Player. Then plug into an AC outlet with
__
ground
hole.
NOTE
• Do riot subject the remote control unit to shock, water or
excessive humidity.
• The remote control unit may not function if tile Player's
remote sensor is in direct sunlight or any other strong light.
• incorrect use of batteries may cause them to leak or burst.
Read tile battery warnings and use the batteries properly.
• Do not mix old and new batteries, or mix different brands.
• Remove tile batteries if you will not use the remote control
unit for an extended period of time.
_! WARNING
• Do riot use or store batteries in direct sunlight or other
excessively hot place, such as inside a car or near a heater.
This can cause batteries to leak, overheat, explode or
catch fire.
it can also reduce tile life or performance of batteries.
To AC IN terminal
To AC outlet
with ground hole
NOTE
• Place tile Player close to the AC outlet, and keep tile
power plug within reach.
• TO PREVENT RiSK OF ELECTRIC SHOCK, DO NOT
TOUCH THE UN INSULATED PARTS OF ANY CABLES
WHILE THE AC CORD IS CONNECTED.
• Tile POWER indicator blinks while the Player is preparing
for starting up. You cannot turn the Player on until tile
POWER indicator stops blinking.
• If you are not going to use this Player for a long period of
time, be sure to remove the AC cord from tile AC outlet.
_-
21
Advertisement
Table of Contents
