Falling Prevention; Installing The Amplifier System - Sharp HT-SL72 Operation Manual

4 Screw the wall mount angle to the wall as shown in
the illustration. (Total screw is 4 pieces)
• Make sure that the screw and the wall can support
a load of 45 Ibs (20 kg).
Wall mount angle
"_ ..... E. Wall
ws x 2) / ' "_ mount
/- ,,,,/ ang e
Wall surface ( _
....... (screws x 2) X_
5 Align the wall mount slot at the Sound Bar to the
wall mount angle,
6 Slot the Sound Bar into the wall mount angle,
7 Fix them securely,
Note:
Make sure all screws are fully tightened. (screws are not
supplied)
Safety wires (not supplied) are useful to prevent the Sound
Bar from falling off the table.
Loop the safety wires (not supplied) into each hole as
shown and tie the safety wires to the LCD TV stand.
The Amplifier can be installed as below:
1 2 3
Horizontal Vertical On the wall
To mount the Amplifier on the wall, perform the following
steps.
1 Make a hole on the wall using a drill.
_-, 1-1/4" (32 mm)
//iA
(8- 9 mm) _
3/8"
2 Fix a wall mount plug into the hole using a
hammer, until it is flush with the wall surface,
3 Fix screws into the wall for the Amplifier, as
shown in the illustration.
• Make sure that the screw and the wall can support
a load of 45 Ibs (20 kg).
• Fix the screws, so the screw head extends about
7/32" (5.5 mm) from the wall.
Wall surface Wall mounting Wall surface
screw
4 Fix the screws. Hook the Amplifier on the screw
heads and make sure it is properly secured.