Table of Contents
Advertisement
TRACKI
NG
Your VCR has automatic tracking.which removes the streaks or
snow from the picture. Automatic tracking is activated when you
insert a tape, turn on the VCR, or the speed changes during
playback. Occasionally you may need to manually adjust tracking,
especially if the tape was recorded on a different VCR. Just use
the TRACKING buttons to remove the streaks or snow. During
playback, the tracking level meter (with a number) will appear in
the VCR's display. You can also use tracking when you pause a
tape to reduce jittering of the picture.
When you manually adjust the picture, automatic tracking is
turned
off. To turn automatic
tracking
back on, press the
PLAY button
on the remote during playback, or eject the tape
and reinsert it.
TIME
COUNTER
The time counter shows the actual time it takes to record a
program
or play back a segment of a recorded tape. It helps
locate the beginning
or end of programs you taped. The time
counter resets to 0:00:00 whenever
the tape is ejected from
the VCR.
For example, if you record a 30-minute
program
at the beginning
of the tape and you want to go to the end of that program to
begin another
recording,
you would:
1.
Press INFO twice
on the remote to display the time counter.
2.
Press CLEAR to reset the time counter to 0:00:00.
3.
Press FORWARD (FWD) to forward
the tape until the time
counter reads 0:30:00.
.
.
Press STOR This is the approximate
end of the program.
(You may want to press PLAY to verify.) Now, you can begin
recording
at this spot.
Press INFO to remove the time counter from the screen and
return to the normal display mode.
0:30:00
Hours
1
Rinutes
Seconds
39
Advertisement
Table of Contents
