Table of Contents
Advertisement
Model CC635 or CC636:
Install Lithium Cell
The remote's
lithium cell is packed separately.
Install it as follows:
Back of
Remote Control
Holder
1@_
Insert Pencil Here
,
Lithium Cell
Cautions:
Lithium cell battery.
Replace only with 3-volt lithium cell - such as CR2025.
Use of other
cell presents a risk of fire or explosion. Must be disposed of properly.
Never handle punctured or
leaking ceil. May cause bums or personal injury.
Keep out of the hands of children. Ca_ cause death or injury if swallowed.
If swallowed, consult a
physician immediately
for emergency treatment.
The lithium cell used in this device may explode _sulting in a fire or chemical bum if mistreated.
Do
not recharge, disassemble, heat above 212*F (100 C), or incinerate.
Never use metallic tweezers to hold the cell, and never short circuit the + and - sides of the cell.
1. Turn remote over, insert a. pencil or
paper clip in small hole and remove
battery holder.
2. Insert battery in battery holder so
positive (+) terminal faces up.
3. Replace battery holder in remote until
it clicks into place.
Notes:
Never place anything
heavy
on top of
the remote
control
or lay it upside-down.
Replace
battery
when camcorder
fails to
respond
to remote.
Remove
battery
from remote
if it will not be
used for a month or more.
This will prevent
possible
damage
from battery
leakage.
If leakage
occurs,
wipe up liquid inside
compartment
and replace
battery.
Remote Sensor
................
........... ..........
......... ............................
....
The remote
operates
the camcorder
by infrared
light, so it is protected
from electrical
and sound interference.
However,
the remote
must be aimed
directly
at the
camcorder's
remote
sensor.
There
cannot be any obstructions
between
them.
Remote Control Sensor
•
_._,t
"_
,
Note:
The camcorder
may not respond
to the remote
if its sensor
is exposed
to direct
sunlight
or strong
artificial
light.
22
Advertisement
Table of Contents
