ProScan PSVR75 User Manual page 79

WILL NOT RECORD
• Check to make sure the safety tab is intact.
REWIND DOES NOT OPERATE
• Check to make sure the tape is not already rewound.
"MULTIPLE CABLE COMPANIES" PROMPT COMES UP EACH TIME THE VCR IS TURNED ON
• Make sure you have selected the proper channel numbers line from the list shown.
• Manually turn off AUTO VCR Plus+ by going to the MAIN menu, then (4) CHANNELS, (4) VCR Plus+ Setup,
and then (2) to turn off the feature.
VCR PLUS+ OR TIMER RECORDING NOT MADE OR WRONG PROGRAM RECORDED
• Check to make sure the correct VCR Plus+ code is entered.
• Check to make sure the cable box or satellite receiver was turned on when recording was to begin.
• Check to make sure the program was entered correctly (wrong channel or times).
• Power interruption. Reset the clock.
• Check to see if time and date are correct--including AM/PM.
• Check to make sure the program did not exceed the tape's length or the tape was not rewound beforehand.
• Check to make sure the VCR was turned off at the time recording was to start.
• Check to make sure there was a tape in the VCR and the cassette's safety tab was intact.
• VCR ejects cassette when the end of the tape is reached during a timer recording.
• Check to make sure VCR Plus+ setup was completed correctly.
CLOCK
SHOWS INCORRECT TIME OR DATE
• Power interruption. Automatic clock set was not turned on or did not work properly. Check time zone and
daylight-savings settings.
• Make sure VCR or cable box is tuned to channel carrying XDS information.
• Auto clock set is not supported by digital satellite receivers. Set the clock manually.
TIME DID NOT ADJUST FOR DAYLIGHT-SAVING TIME
• Check to make sure daylight-saving feature is set correctly.
VCR MAKES NOISE WHEN STOPPED
• VCR is removing tape from heads. This is normal. The head cylinder inside the VCR will continue to rotate for
a few minutes after you put the VCR in the stop mode.
WILL NOT AUTO CHANNEL SEARCH ACTIVE CHANNELS CORRECTLY
• Check to make sure the antenna connections are secure and correct.
• Check to make sure the Signal Type: CABLE/ANTENNA feature is set correctly.
• If Detect Automatically was selected for the Signal Type in the AUTO CHANNEL SEARCH menu, try using
either CABLE TV or ANTENNA instead.
• May not be necessary if using a cable box for all channels. Contact your local cable company for more
information.
TAPE PLAYS BACK IN SLOW MOTION
• Press PLAY to return to normal playback.
CASSETTE WITH SAFETY TAB REMOVED DOES NOT START TO PLAY AUTOMATICALLY
• Check to make sure the Auto Play ON/OFF feature is set to ON.
TIMER OR TAPE INDICATOR FLASHES
• Check to make sure there is a cassette in the VCR when a timer recording is set.
77