Setting Rgb Delay; Example 6: Setting The Rgb Delay For An Output - Extron electronics VGA MATRIX SWITCHERS MVX PLUS 128 User Manual

Setting RGB delay

The switcher can briefl y blank the RGB (video) output while it switches to the
new input's sync source, and then switches the RGB signals. This allows a brief
delay for the display to adjust to the selected input's sync timing before displaying
the new picture, which then appears without glitches. RGB delay, also known as
Triple-Action Switching or video mute switching, is user selectable from 0 to 5
seconds, in half-second increments.
You can set the RGB delay interval on the front panel or by using RS-232/RS-422
and Ethernet ports with either the SIS, Windows control program, or HTML pages.
(See chapter 4, Programmer's Guide; chapter 5, Matrix Software; and chapter 6, HTML
operation). Specify the RGB delay interval for a specifi c output on the front panel as
follows:
1. Press the Esc button to clear any input buttons, output buttons, or control
buttons that may be lit.
2. To enter RGB Delay mode, press and hold the RGBHV button until the button
begins to blink green, then release the button.
3. Press and release an output button to select an output. Each lit input button,
from Input 1 through Input 10, indicates a half second of RGB delay interval
for the selected output.
4. Press and release the Esc (
the interval.
5. Press and release the RGBHV button to exit the RGB Delay mode. The
RGBHV button stops blinking.
N • Pressing the Enter or Preset button also exits RGB Delay mode. Pressing
the Preset button changes to Recall Preset mode.
• The RGB interval for each output is stored in non-volatile memory. When
power is removed and restored, the delay settings are retained.
• Exiting RGB Delay mode by pressing the RGBHV button always returns
the I/O confi guration to audio only selected for confi guration.

Example 6: Setting the RGB delay for an output

In the following example, the RGB delay is increased for output 1. The steps show
the front panel indications that result from your action.
1. Press and release the Esc button (fi gure 3-34).
Press the Esc button to clear all selections.
C O N T R O L
ENTER PRESET
The button flashes once.
Figure 3-34 — Clear all selections
) and View (
VIEW ESC
MVX Plus 128 VGA Matrix Switchers • Operation
) buttons to increase and decrease
3-21