Advertisement
The steps below will help you get
your TV connected
and working
quickly.
The page numbers
on which
you can find detailed
instructions
for
each of these steps are also listed for
your convenience.
1.
Unpack TV and accessories.
Shown here are the accessories that came
packed with your TV.
oeoE91
@ @® Lv.JI
g_&g l
Antenna
Adapter
Remote
Control and
Two AAA Batteries
2.
Connect antenna
or cable-TV
system.
Most antenna or cable-TV systems can
be connected as shown here.
Incoming
Cable from Antenna or
Cable--TV System
Back
of TV
Details for connecting a home antenna
to your TV are on page 17.
Details for connecting a cable-TV
system to your TV are on page 18.
Details for connecting a VCR to your
TV are on page 20.
3.
Attach power cord.
First attach the fiat end of the power cord
completely into the connector on the
back of your TV, and then plug the other
end into a wall outlet.
•Do This
Back Of TV
2nd
Not This
4.
Install batteries
in remote
control.
Details are on page 6.
5. Turn on TV, adjust the volume,
and select a channel.
Number--
Buttons
_emee_e_
eeel_l.
"® ® ® I__1
_
(,9 r_ L.Y.J
--TV
Bu_on
CHAN (Channel)
Buttons
--
VOL (Volume)
Buttons
Press the TV button on the remote to
turn on the TV. When using the
remote, remember to point it at the
front of the TV.
Note: Pressing the TV button puts the
remote in the "TV Mode" so it can control
the TV. Pressing the VCR button puts the
remote in the "VCR Mode" so it can control
a compatible VCR. Always make sure the
remote is in the "TV Mode" by pressing the
TV button when you are trying to control
the TV.
Press the VOLUME up or down button
to adjust the volume to a desired level.
Press the CHANNEL up or down button
to select the next channel in memory.
You can also press two number buttons
to select a channel. To select a 3-digit
number (up to 125), press and hold
number button 1 until 1-- appears on
the screen. Then press the other two
numbers. Channels 2-13 were
programmed into the channel memory
for you at the factory, so pressing
CHANNEL up or down stops at these
channels only. When you start the
autoprogramming feature (described in
step 6), your set will automatically scan
through all channels and place only the
active channels for your area into its
channel memory.
Details about using the remote are on
page 7.
6.
AutoProgram
the TV's channel
memory.
To start the TV autoprogramming itself,
repeatedly press the SETUP button to
select (highlight) the A UTOPROGRAM
function, and then press +. Details are
on page 13.
2nd
Menu
You can also add and erase channels
from memory as desired by repeatedly
pressing SETUP to select (highlight) the
EDIT CHANNELS function. Then press
+ or - to enter the function.
2nd
Menu
Select the desired channel number by
pressing the CHANNEL up or down
buttons or by pressing the two
corresponding number buttons.
Then press + to add a channel, or press
- to erase a channel. Details are on
page 13.
Advertisement
