ProScan PSVR71 User Manual page 75

HOW
TO
FIND YOUR TV'S
VIDEO INPUT CHANNEL
You need to tune your TV to the Video Input Channel if you are using
the VCR's AUDIO/VIDEO OUT jacks to connect to the TV's AUDIO/
VIDEO INPUT jacks. You must select this "channel" before you can
see the VCR's menus, the cable or antenna reception, and the content
that's on a tape.
The Video Channel on TVs varies for different brands and different
models. Below are some steps to try:
• If your TV brand is RCA, GE, or PROSCAN, press the TV button on
the remote control that came with the VCR. Then press the INPUT
button on the remote.
• If you have another brand of TV, consult the section, Programming
The Remote, to see if the VCR's remote control can be set to
control your TV. If so, follow the step above.
If those options do not work, try the following ideas. You might access
the Video Input Channel by:
• pressing a button on the remote (see table below)
• selecting the channel from the TV's menu system
(see table below)
• tuning directly to the channel by selecting a specific channel
number (see table below)
• going through all the channels in the channel list by pressing the
channel up or down buttons on the TV.
Some common scenarios are listed in the Video Input Channel
Variations table that follows:
Video Input Channel Variations
Button/Switch Button on the Channel
on the TV TV Remote Number
VIDEO VID 1 00
SIGNAL LINE 90
VID 1 VID 91
VID 2 VIDEO 92
S-VI D S-VI D 93
S-VIDEO INPUT VID 1
S-VIDEO VID 2
SOURCE
AUX
INPUT
Button _
"IV
Button
VCR1 ON • OFF TV
DVD VCR2 AUX SAT*CABLE
&&°&&
MUTE SEARCH
SPEED GO BACK
GUIDE INFO
MENU CLEAR
1| 2_ 3|
4| 5_ 6_
7_ 8_ 9_
0 _ ANTENNA
REVERSE PLAY FORWARD
RECORD STOP PAUSE
-TRACKING + EDIT FR.ADV
OOOO
73