Table of Contents
Advertisement
j TROUBLESHOOTING
.................................................................................
Incorrect operations are often for trouble and malfunctions.
If you think that there is something
wrong with this component,
check the points below. Sometimes
the trouble may lie in another component.
Inspect the other components
and electrical
appliances being used. If the trouble
cannot be rectified
even after exercising
the checks listed below, ask your nearest
PIONEER authorized service center or your dealer to carry out repair work.
SYMPTOM
CAUSE
REMEDY
1. Disc table is not ejected when
• Power cord is not properlyplugged into AC wall
•
Plug in power cord.
A is pressed,
socket.
• Power switch is not turned on.
• Turn on power switch.
2. Disc table comes out.
3. Remote control does not work.
4. Operation of the remote control
unit causes the TV to operate
improperly.
•
Disc is dirty.
•
The disc is not properly set on the disc table,
•
Moisture has condensed on parts in the player.
•
Disc is warped.
•
The CONTROL IN terminal on the rear panel is
connected
to Pioneer projection
monitor
or AV
amplifier.
•
Batteries are weak.
•
There is an obstacle between
the player and the
remote control unit.
•
Remote control unit is not in a good location for
transmission.
•
Some "IV sets have remote control functions that
operate improperly
in response
to the remote
control unit of the player.
•
Clean disc.
•
Set the disc properly.
•
Remove disc and let player stand for 1
to 2 hours until it is dry.
•
Try to alleviate
the warp.
(Refer
to
Symptom
7, remedy column.)
•
Aim the remote
control
unit at the
projection
monitor or AV amplifier.
•
Replace batteries.
•
Remove
the obstacle
or shift
the
remote control position.
•
Operate the remote control unit in front
of the player.
•
Move the TV and the player further
apart, of cover the remote sensor of
the TV during disc playback.
Abnormal
functioning
of this unit may be caused by
static electricity or other external interference. To restore
normal operation, unplug the AC power cord and then
plug it in again.
4O
<VRB1142>
Hide quick links:
Advertisement
Table of Contents
