Pioneer LaserDisc CLD-D704 Operating Instructions Manual page 12

CONNECTIONS
Stereo amplifier connections
Connect the AUDIO OUT jacks of the player to the AUX,
CD or LD input jacks of your stereo amplifier.
NOTE:
Do not connect these terminals to your amplifier PHONO
input jacks.
Connecting to the digital jack
This unit can be connected to an amplifier equipped with
an optical digital jack or coaxial digital jack.
NOTE:
The optical fiber cable and coaxial cable are not suppfied
with this unit. Use a separately sold optical fiber cable or
coaxial cable for the digital jack connections.
• When using the OPTICAL DIGITAL OUT jack:
1. Remove the protective dust cap from this unit's
OPTICAL DIGITAL OUT jack.
2. Use an optical fiber cable to connect OPTICAL DIGITAL
OUT jack of this unit to the optical digital input jack of
the amplifier.
• Align the plug of the optical fiber cable with the optical
digital jack and fully insert the plug to make a secure
connection.
NOTES:
• When making optical digital connections, this player
can only be connected to an ampfifier which uses the
same type of optical transmission/reception module.
• Fully insert the optical fiber cable plugs all the way
into the jacks.
• Be careful not to fold or crimp the cable. When coiling
an optical fiber cable for storage, make sure the
diameter of the coil is 15 cm (6 inches) or larger.
• Use an optical fiber cable with a length of 3 m (10
feet) or less.
• Protect the optical fiber cable plugs from scratches
and dust.
• when the unit is not connected using an optical fiber
cable, be sure to keep the protective dust cap plugged
into the optical digital output jack at all time.
• When using the COAXIAL DIGITAL OUT jack:
Use a coaxial digital cable to connect the COAXIAL
DIGITAL OUT jack of this unit to the coaxial digital input
jack of the amplifier.
L_ --_ CD, AUX, VDP,
/ LD, VCR, etc. =
I _ Audio cord I • o o
........... • , ,
,,_,,, I(_1 ,, _n'_n / • _ : /1 li /t I ==o=
Ior-_l === o__Jo
: n "--- ---
I I
# /
_u_,_L IT o
coaxial _, T T V /L_
t_ __._" "'" I digital jack . r I-_q] _
=1 /
t_J
\ v, iN .... I TO°ptical | _ /
I, I digital j ack / I _ I _ [ [ --___ /
m tL_ Remove the cap.
' ........ U
a Optical fiber cable i _ _ _
_=mnllllmninllmB _li_
Plug the AC power cords of the player, stereo
amplifier and TV set into an AC outlet.
When the power cord of this unit is connected to an AC
outlet, power is supplied to the unit's internal memory
(such as the last memory) even when the PIONEER switch
is OFF. Therefore, be sure to connect the power cord
directly to a wall outlet. If the power cord is connected to
an outlet such as a switched outlet on an amplifier, the
various memory contents will be erased whenever the
amplifier's power switch is turned off.
Stereo amplifer
AC outlet
12
<VRB1142>