To Search For A Particular Passage - Pioneer LaserDisc CLD-D704 Operating Instructions Manual

TO SEARCH FOR A PARTICULAR PASSAGE
LIJICDV I_,LD
J Search the SHUTTLE and JOG dial
using ring
Using the Shuttle Ring and Jog Dial changes playback speed
and direction. This function is useful to search for a desired
passage.
Front panel
® ® ®
] :Jl/
Io o oo/|
I, .I
Jog dial
Shuttle ring
JOG MODE indicator/ m
Jog indicator
Remote control unit
SCAN PUW
-C J
Jog dial
Shuttle ring
l
Jog dial (LD/video part of CDV)
Playback is advanced according to the speed and direction of
rotation of the JOG dial. Both forward and reverse playback is
possible, and frames can be advanced at speeds of 1/2 speed,
normal speed, and double speed. Rotating the jog dial clockwise
forwards playback. Conversely, rotating it counterclockwise
left reverses playback. To use the JOG dial on the remote
control unit, first press JOG MODE so that Jog indicator lights.
During playback of an LD or CDVvideo part, when the JOG dial
stops rotating, the frame is displayed.
Shuttle ring
While rotating the SHUTTLE ring, playback advances or
reverses at high speed. There are four scan modes which can
be selected with rotational angles of the SHUTTLE ring.
x2 speed: Slightly rotate the SHUTTLE ring. Scan speed
becomes about x2 the normal playback speed.
x5 speed: Further rotate the SHUTTLE ring. Scan speed
becomes about x5 the normal playback speed.
Low Scan mode: Rotate the SHUTTLE ring furthermore.
Scan speed becomes about xl 0 the normal playback speed.
High Scan mode: Fully rotate the SHUTTLE ring at greater
angle. Scan speed becomes about x20 the normal playback
speed.
The SCAN buttons on the remote control unit can also be used
to enter scan mode.
SCAN SCAN
If the SCAN button on the remote control unit is pressed
without the image on the screen, Clear Scan is performed.
If the SCAN button on the remote control unit is pressed
with the image on the screen, high speed scan is performed.
Scan speed becomes faster in 2 seconds except for the
video part of CDV.
To switch the screen display, press the DISPLAY button.
• With video part of CDV, High Scan mode cannot be carried
out.
• CDs or audio part of CDVs: Sound is heard at low volume
level while scanning.
Others: Sound is muted.
To resume normal p|a_/back after using the JOG diat:
Press PLAY i-.
When not using the JOG dial on the remote control unit, set JOG
MODE to OFF.
Although JOG MODE will automatically switch OFF (The Jog indicator
goes out) approximately 5 minutes after you stop operating the JOG
dial, it is recommended that you set JOG MODE to OFF as soon as
you finish using the JOG dia_in order to prevent unnecessary battery
consumption.
Notes on CAV:
While scanning, noise may occur on the screen. This is not_ a
malfunction.
25
<VRB1142>