Table of Contents
Advertisement
| TROUBLESHOOTING
electrical appliances being used.
SYMPTOM
CAUSE
REMEDY
1. Disc table comes out.
@ Disc is dirty.
@ The disc is not properly set on the disc table.
®@ Moisture has condensed on parts in the
player.
@ LD disc is warped.
Refer to instructions under "Remedy", item
8, and clean disc.
Set the disc properly.
Remove disc and let player stand for 1 to 2
hours until it is dry.
Try to alleviate the warp,
{Refer to Symptom 8, remedy column.)
2. TV no longer receives other
channels after it has been con-
nected to the player.
@ Antenna cable has not been connected,
® LDP mode is selectd.
Connect UHF antenna cable to antenna
terminal on the player.
Select the TV mode by pressing the TV/LDP
key or turning off the player's POWER switch.
Ca. Slanting stripes appear on the
TV screen when TV/LDP key is
pressed to receive TV broadcasts.
® Electric field for TV broadcasting is weak.
(This does not indicate any trouble.)
Turn off the POWER switch of the player.
We recommend that you turn off the POWER
switch of the player, whenever you intend to
watch TV for a fong time.
4. Remote control does not work.
@ The CONTROL IN terminal on the rear panel
is connected to Pioneer projection monitor or
AV master amplifier.
® Batteries are weak.
@ There is an obstacle between the player and
the remote control unit.
@ Remote control unit is not in a good location
for transmission.
e
Aim the remote control unit at the projection
monitor or AV master amplifier
Replace batteries.
Remove the obstacle or shift the remote
control position.
Operate the remote control unit in front of
the player.
5. Operation of the remote control
unit causes the TV to operate
improperly.
® Some TV sets have remote control functions
that operate improperly in response to the
remote control unit of the player.
4
Move the TV and the player further apart, or
cover the remote sensor of the TV during
disc playback.
WHEN ALD DISC IS BEING PLAYED
6.
Disc is rotating but there is no
picture.
@ The TV set is not turned on.
© Wrong connections from player to TV.
@ The TV channel and the player's setting
channel are different.
®@ TV mode is selected.
Turn on TV.
Make correct connections.
Tune the TV to any channel between 32 and
40, and adjust the CHANNEL SELECTOR on
the rear panel of the player.
Select the LDP mode by pressing the TV/LDP
key on the remote controf unit.
7.
Picture continuously moves
vertically,
®@ The TV vertical hold control is not adjusted
properly.
Adjust vertical-hold control on TV.
27
<VRB1022>
Advertisement
Table of Contents
