Troubleshooting - Maytag Bravos MEDX600XW0 Use And Care Manual

TROUBLESHOOTING
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
to possibly avoid the cost of a service ca[[...In U.S.A. htt)://www.maytag.com/he[p - In Canada www.maytag.ca
If you experience Possible Causes Solution
Clothes are not drying Lint screen clogged with lint. Lint screen should be cleaned before each load.
satisfactorily, drying
times are too long, or Has the Air Dry cycle been selected. Select the right cycle for the types of garments being dried.
load is too hot See "Air Dry."
Load too large and heavy to dry Separate the load to tumble freely.
quickly.
Exhaust vent or outside exhaust Run the dryer for 5-10 minutes. Hold your hand under the
hood clogged with lint, restricting outside exhaust hood to check air movement. If you do not feel
air movement? air movement, clean exhaust system of lint or replace exhaust
vent with heavy metal or flexible metal vent. See the Installation
Instructions.
Fabric softener sheets blocking Use only one fabric softener sheet, and use it only once.
the grille.
Exhaust vent the correct length? Check that the exhaust vent is not too long or has too
many turns. Long venting will increase drying times. See the
Installation Instructions.
Exhaust vent diameter the Use 4" (102 mm) diameter vent material.
correct size.
Dryer located in a room with Proper operation of dryer cycles requires temperatures above
temperature below 45°F (7°C)? 45°F (7°C).
Dryer located in a closet. Closet doors must have ventilation openings at the top and
bottom of the door. The front of the dryer requires a minimum of
1" (25 mm) of airspace, and, for most installations, the rear of the
dryer requires 5" (127 mm). See the Installation Instructions.
Dryer will not run Door not closed completely. Make sure the dryer door is closed completely.
START/PAUSE button not pressed Press and HOLD the START/PAUSE button until you hear the dryer
firmly or held long enough, drum moving.
Household fuse is blown or circuit Electric dryers use 2 household fuses or circuit breakers. The drum
breaker has tripped, may be turning, but you may not have heat. Replace the fuse or
reset the circuit breaker. If the problem continues, call
an electrician.
Incorrect power supply. Electric dryers require 240-volt power supply.
Check with a qualified electrician.
Wrong type of fuse. Use a time-delay fuse.
Unusual sounds Dryer have a period of non-use. If the dryer hasn't been used for awhile, there may be a
thumping sound during the first few minutes of operation.
Is a coin, button, or paper clip Check the front and rear edges of the drum for small objects. Clean
caught between the drum and front out pockets before laundering.
or rear of the dryer?
Is it a gas dryer? The gas valve clicking is a normal operating sound.
Are the four legs installed, and is the The dryer may vibrate if not properly installed.
dryer level front to back and side to See the Installation Instructions.
side?
Clothing knotted or balled up. When balled up, the load will bounce, causing the dryer to
vibrate. Separate the load items and restart the dryer.
No heat Household fuse is blown or circuit The drum may be turning, but you may not have heat. Electric
breaker has tripped, dryers use 2 household fuses or circuit breakers. Replace both
fuses or reset the circuit breaker. If the problem continues, call
an electrician.
Supply line valve not open. For gas dryers, is the valve open on the supply line.
Incorrect power supply. Electric dryers require 240-volt power supply.
Check with a qualified electrician.
J
12