Table of Contents
Advertisement
Available languages
Available languages
2.
Adjust leveling legs
If dryer is not level, prop up using a wood block, use wrench
to adjust legs up or down, and check again for levelness. Once
legs are level, make sure all four legs are snug against the floor.
COMPLETE INSTALLATION
CHECKLIST
q
Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
q
Check that you have all of your tools.
q
Dispose of/recycle all packaging materials.
q
Be sure the water faucets are on.
q
Check for leaks around "Y" connector, faucets, and hoses.
q
Check dryer's final location. Be sure vent is not crushed
or kinked.
q
Check that dryer is level. See "Level Dryer."
q
Remove film on console and any tape remaining on dryer.
q
Wipe dryer drum interior thoroughly with a damp cloth to
remove any dust.
q
Read "Dryer Use" in your Use and Care Guide.
q
If you live in a hard water area, use of a water softener is
recommended to control the buildup of scale through the
water system in the dryer. Over time, the buildup of lime
scale may clog different parts of the water system, which will
reduce product performance. Excessive scale buildup may
lead to the need for certain part replacement or repair.
Electric Models:
q
Plug into a grounded outlet.
Gas Models:
q
Check that gas supply is on.
q
Check for leaks.
16
All Models:
q
Select a Timed Dry heated cycle, and start dryer. Do not
select Air Only Temperature setting.
If dryer will not start, check the following:
• Controls are set in a running or "On" position.
• Start button has been pushed firmly.
• Dryer is plugged into an outlet and/or electrical supply is
connected.
• Household fuse is intact and tight, or circuit breaker has
not tripped.
• Dryer door is closed.
This dryer automatically runs an installation diagnostic routine
at the start of its first cycle.
NOTE:
You may notice an odor when dryer is first heated. This
odor is common when heating element is first used. The odor will
go away.
DOOR REVERSAL
If you prefer to reverse the door swing on your dryer: A door
reversal kit, Part Number W10277499, is available to order. For
further information, see "Assistance or Service" section in your
Use and Care Guide.
STACKING WASHER AND DRYER
If you prefer to stack your washer and dryer: A stack kit, Part
Number 8572546 is available to order. For further information,
see "Assistance or Service" section in your Use and Care Guide.
TROUBLESHOOTING
See the Use and Care Guide or visit our website and reference
"Frequently Asked Questions" to possibly avoid the cost of a
service call.
Advertisement
Table of Contents
