r
3.
Press POWER/CANCEL
power
cancel
Press the POWER/CANCEL button to turn on the dryer.
4.
Select the desired cycle
eco normal
normal
wrinkle control
delicate
sani-
extra
tize
delicate
cydes
timed cycles
dry
up
rapid
dry
Select the desired cycle for your load. See the "Cycle Guide"
or the display for more information
about each cycle.
f5.
Setting modifiers
timed dry adjust
estimated time
remaining
•
high
•
medium
• low
• extra low
• air dry
temp
[eve[ 1
modifiers
•
more
•
normal
•
150 min.
•
less
•
60 min.
The default cycle settings will be shown. For some cycles,
you may select alternate settings by pressing the button for that
setting. Time adjusts for Manual Cycles only.
NOTE: Not all modifiers are available with all cycles.
Temp Level (for use with Timed Cycles only)
Press the TEMP LEVEL button
to change the drying
temperature
from the default
setting.
Press the (+) for more time or (-) less
time and the time will
change by 1 -minute
intervals.
Press and
hold (+) for more time or (-) less time and the time will change by
5-minute
intervals.
Dryness Level (for use with Sensor Cycles only)
You can select a different dryness level, depending on your load,
by pressing the button for More, Normal, or Less. Selecting More,
Normal, or Less automatically adjusts the dryness level at which
the dryer will shut off. Once a dryness level is set, it cannot be
changed without stopping the cycle.
Sensor Dry cycles give the best drying in the shortest time. Drying
time varies based on fabric type, load size, and dryness setting.
NOTE: More Dry removes more load moisture. Normal Dry is
used for a starting point for sensor drying. Less Dry removes less
moisture and used for loads you may want to put on a hanger to
complete drying.
Wrinkle
Prevent feature
•
Get up to 60 or 150 minutes for models with two choices,
90 minutes for models with only one choice of heat-free,
periodic tumbling at the end of a cycle. Press the WRINKLE
PREVENT button to turn ON or OFF at any time before the
cycle has ended.
•
The WRINKLE PREVENT feature is preset to "OFF." If selected
for other cycles, the WRINKLE PREVENT feature setting will
remain "ON" the next time that cycle is selected.