Goldstar RI000 Owner's Manual page 26

[] Cabinet Installation
1. Open the window MaA a Jineon the center
of the window stool be_een the side
window stop moldings.
Loosely attach the sill bracket to the support
bracket using the carriage bolt and the lock
nut.
Bra Ill Support
II Bracket
Car ring e" LP'-
Bolt Lock nut
(M-Screw)
Fig. 5
2. Attach the sill bracket to the window sill
using the screws (Type B).
Carefully place the cabinet on the window
stool and align the center mark on the
bottom front with the center line marked
window stool
Cabinet====_..H
Track tlole 1_
S,upport----_
Bracket L
and
Machine s crew(Ty_O}
,and locknut
_" O_t_r_doge
:_-=- Screw(Type B)
\ S,il_ bracket
Fig. 6
3. Using the M-screw and the lock nut, attach
the support bracket to the cabinet track hole.
Use the first track hole after the sill bracket
on the outer edge of the window sill. Tighten
the carriage bolt and the lock nut. Be sure
the cabinet slants outward.
CAUTION:
Do not drill a hole in
the bottom pane The unit is designed
to operate with approximately 1/2" of water
in bottom _n,
4. Pull the bottom window sash down behind
the Top retainer bar until they meet.
1. Do not pull the window sash down so
tightly that the movement of Frame
curtain is restricted. Attach the cabinet to
the window stool by driving the screws
(Type B) through the cabinet into window
stool.
2. The cabinet should be installed with a
very slight tilt downward toward the
outside.
retainer
mr
Window stoo_
Front a ngle Fig. 7
Win_w sash ) retainer bar
Frame curtain
Foam°PE
Fig. 8
track
Front Angle
Screw(Ty_ B) Fig. 9