Cabinet Installation - Goldstar RI000 Owner's Manual

[] Cabinet Installation
Open the window. Mark a line on center
of the window stool(or desired air
conditioner location).
Carefully place the _binet on the
window stool and align the center mark
on the bottom front with the _nter line
marked in the window stool.
2. Pull the bottom window sash down
behind the upper guide until it meets.
not pull the window sash down
tightly that the movement of
Frame Curtain is restrict.
3 Loosely assemble the sill support using
the pa_s (Fig_3)
4. Select the position that will place the sill
suppo_ near the outer most point on sill.
(Fig 4)
Be careful when you install the
cabinet (frame guides ,_fi_ are
5_
6_
7_
8_
Attach the sill support to the cabinet
track hole in relation to the selected
position using 2 Type A screws in each
support. (Fig. 4)
The cabinet should be installed with a
very slight tilt(about V2") downward
toward the outside. (Fig. 5)
Adjust the bolt and the nut of silll support
for balancing the cabinet.
Attach the cabinet to the window stool
by driving the screws _:6;_ (Type B:
Length sixteen millimeters and below.)
through the front angle into window
stool_
Pull each Frame curtain fully to each
window sash track, and repeat step 2.
Upper Guide
Window stoo_
'Front Angle
Fig, 1
Upper guide Q
Foam.pe_ Fig. 2
Frame Guide_
\,
Screw(Type A)
Cab4net
INDOOR
OUTDOOR Fig. 4
Screw(Type B)
Sash track
SilJ suppoN_
Front Angle
Screw(Type B)_
Fig. 5