Panasonic SC-HT733 Operating Instructions Manual page 27

r 8UBW00FER
You can adjust the amount of bass. The unit automatically selects
the most suitable setting according to the type of playing source.
Press [SUBWOOFER LEVEL].
eWhen DVD-Video or DVD-RAM is selected
SUB W4 (factory preset)_SUB W I_SUB W 2_SUB W 3
_' I
• When another source is selected
SUB W2 (factory preset)_SUB W 3_SUB W 4_SUB W 1
= I
The setting you make is retained, and recalled every time you play
the same type of source.
2
3
This is one of the ways to get appropriate surround effects.
Preparation
Press [DVD/CD].
While stopped and no on-screen display is shown
Press [SHIFT]+[TEST] to output a test
signal.
L: Front left C: Center R: Front right
RS: Right surround LS: Left surround
eThere is no output from SW (subwoofer) channel.
Press [VOLUME, +] or [--] to set the
volume level normally used for listening.
Press [&] (increase) or [V] (decrease) to
adjust the speaker level for each speaker.
C, RS, LS: 6dBto +6dB
(L, R: Only the balance is adjustable.)
eTo adjust the balance of the front speakers
While outputting the test signal, press [<, I_].
eAdjust the speaker level to the same level as the front
speakers.
To stop the test signal
Press [SHIFT]+[TEST] again.
• To adjust speaker level during play
(Effective when playing multi-channel audio or when Dolby Pro
Logic I1 or Super Surround is on.)
Press [CH SELECT] to select the speaker.
2
L --->C --->R --->RS --->LS --->SW
¢ I
SW: Subwoofer
eYou can adjust SW only if the disc includes a subwoofer
channel.
• "SW" does not appear on the display and is not adjustable
when Dolby Pro Logic 11is turned on.
e"S" appears on the display when "MUSIC" or "MOVIE" is
selected with Super Surround (-_ page 26). In this case, you
can adjust both surround speaker levels at the same time
using [A, T].
S: 6dBto+6dB
Press [A] (increase) or [V] (decrease) to adjust the
speaker level for each speaker.
C, RS, LS, SW: 6dBto+6dB
(L, R: Only the balance is adjustable.)
• To adjust the balance of the front speakers
While "1" or "R" is selected, press [<, I_].
Press [SHIFT]+[SLEEP] to select the time (in
minutes).
SLEEP 3O_SLEEP 6O_SLEEP 90 ,_ .... ,
¢ OFF_-_SLEEP 120_
To cancel the timer
Press [SHIFT]+[SLEEP] to select "OFF".
To confirm the remaining time
Press [SHIFT]+[SLEEP] again.
To change the setting
Repeat the procedure from the beginning.
Press [MUTING].
"MUTING" flashes on the unit's display.
To cancel
ePress [MUTING] again or reduce the volume to minimum (- -dB),
then raise it to the required level.
• Muting is canceled when you switch the unit to standby.
1
Reduce the volume and connect the
headphones (not included).
Headphone plug type: 3.5 mm (1/8,,)stereo
VOLUME
ql
Adjust headphone volume with
[VOLUME].
eAudio is automatically switched to stereo (2-channel).
Avoid listening for prolonged periods of time to prevent hearing
damage.
=
o
o
=
o
RQT7972