Panasonic SC-HT733 Operating Instructions Manual page 25

• FM frequency step
You can change the FM step. The step is factory-set to 0.2 MHz, but
you can change it to receive broadcasts allocated in 0.1-MHz steps.
1 Press [INPUT SELECTOR] to select "FM'.
2 Press and hold [INPUT SELECTOR].
After a few seconds the display changes to show the current
minimum frequency. Continue to hold the button down. The
minimum frequency changes and the step is changed.
To return to the original step, repeat the above steps.
After changing the setting, previously preset frequency will be
cleared. Preset it again.
Use outdoor antennas if radio reception is poor.
• Disconnect the antenna when the unit is not in use.
• Do not use the outdoor antenna during an electrical storm.
FM outdoor antenna (Using a television antenna)
• Disconnect the FM indoor antenna.
• The antenna should be installed by a competent technician.
Rework your outdoor antenna's 75 O coaxial cable as follows.
75 O coaxial cable ,_"
(not included) //
The illustration shows SC-HT730
for U.S.A. and Canada.
Leave the AM loop antenna connected.
AM outdoor antenna (Using a vinyl wire)
Run a piece of vinyl wire horizontally across a window
or other convenient location.
5-12 m
(16 -39 feet)
.£
d_ Remove a piece of the
outer vinyl insulator.
10 mm (W32")
$
10 Peel back
$
7 mm (%2")
@ Carefully pull the
tabs apart to
remove the cover.
(_ Install the coaxial cable.
Clamp the cable conductor,
and wind it on so that it does
not contact anything else.
Clamp with pliers
(4_ Attach the cover.
RQT7972