Important Safeguards And Precautions - Panasonic Omnivision PV-8455S Operating Instructions Manual

Omnivision vhs
Hide thumbs Also See for Omnivision PV-8455S:
Table of Contents

Advertisement

Important
Safeguards
and Precautions
FOR YOUR
SAFETY,
READ
AND
RETAIN
ALL
SAFETY
AND
OPERATING
INSTRUCTIONS.
HEED
ALL
WARNINGS
IN THE MANUAL
AND ON THE UNIT
I
INSTALLATION
I
1
POWER
SOURCE
CAUTION
Operate only from a power source indicated on the
unit or in this manual. If necessary, have your Electric
Utility Service Company or Video Products Dealer vedly
the power source in your home.
• 2
POLARIZED
OR GROUNDING
PLUG
As a safety feature, this Video product comes with either
a polarized power cord plug (one blade is wider than the
other), or a three-wire grounding type plug.
pOLARIZED
PLUG
CAUTION:
This plug will only fit into an outlet one way. If you cannot
fully insert the plug, try reversing it. If it still will not fit, have
an electrician install the proper wall outlet. Do not defeat the
• safety feature by tampering
with the plug.
GROUNDING
PLUG
CAUTION:
This plug will only fit into a three-hole grounding ouUet. If
necessary, have an electrician install the proper outlet. Do
not defeat the safety feature by tampering with the plug.
POWER
CORD
Make sure power cords are routed so that they 6re not
likely to have anything rest on them, roll over them, or be
in the way of walking traffic.
If an extension cord is used, make sure it also has either
a polarized or grounded plug and that the cords can be
securely connected.
Frayed cords, damaged plugs, and damaged or cracked
wire insulation are hazardous and should be replaced by
a qualified service technician.
Overloaded outlets and extension cords are fire hazards
and should be avoided.
4
DO NOT
BLOCK
VENTILATION
HOLES
Ventilation openings in the cabinet release heat
generated during operation. If they are blocked, heat
build-up inside the unit can cause failures that may result
in a fire hazard or heat damage to cassettes.
For protection, follow these rules:
a. Never cover ventilation slots or the unit while in use,
or operate the unit when placed on a bed, sofa, rug,
or other soft surface.
b. Avoid built-in installation, such as a book case or
rack, unless proper ventilation is provided.
AVOID EXTREMELY
HOT LOCATIONS
OR SUDDEN
TEMPERATURE
CHANGES
Do not place the unit over or near any kind of heater or
regulator, in direct sunlight, inside a closed vehicle, etc..
Do not move the unit suddenly between areas of
extreme temperature variation. If the unit is suddenly
moved from a cold place to a warm place, moisture
may condense in the unit and on the tape.
6
TO AVOID
PERSONAL
INJURY
• Do not place unsecured equipment on a sloping
surface.
--
-
• Do not place this unit on any support
that is not firm, level, and adequately
strm_g. The unit could fall causing
serious injury to a child or adult and
damage to the unit.
• An appliance and cart combination
should be moved with care.
Quick stops, excessive force, and
uneven surfaces may cause the
appliance and cart combination to overtum.
• Carefully fellow all operating instructions and use
the manufacturer's recommended acoessodes
when operating this unit or connecting it to any
other-equipment.
I
OUTDOOR
ANTENNA INSTALLATION
I
1
SAFE
ANTENNA
AND
CABLE
CONNECTION
If an ou_ide antenna or cable system _"'_ - _c.,,_
is connected to the equipment,
====_=0=
be sure the antenna or cable system
is grounded so as to provide some
=o=,=
protection against built up static
--_:;:
charges and voltage surges .....
(in Canada, part I of the Canadian
Electrical Code) provides information
with respect to proper grounding of the
mast and supporting structure, grounding
,,=,_m,=v_
of the lead-in wire to an antenna discharge unit,
size of grounding conductors, location of antenna discharge unit, connection
to grounding electrodes and requirements for the grounding electrode.
2
KEEP
ANTENNA
CLEAR
OF HIGH VOLTAGE
POWER
LINES
OR CIRCUITS
An outside antenna system should be located well away from power lines,
electdc light or power circuits and where it will never come into contact with
these power sources if it should happen to fall. When installing an outside
antenna, extreme care should be taken to avoid touching power lines,
circuits or other power sources as this could be fatal. Because of the
hazards involved, antenna installation should be left to a professional.
I
USING THE VIDEO UNIT
=
.If the unit has been in storage
or moved to a new location,
refer first to the INSTALLATION
section of these
safeguards.
1 KEEP
THIS
VIDEO
UNIT
AWAY
FROM
WATER
OR
MOISTURE
OF ANY
KIND.
2
IF EQUIPMENT
IS EXPOSED
TO RAIN,
MOISTURE,
OR
STRONG
IMPACT,
unplug the unit and have it inspected by a qualified
service technician before use.
3 DURING AN ELECTRICAL
STORM
During a lightning storm, whether indoors or outdoors, or before leaving the
unit unused for extended periods of time, disconnect all equipment from the
power source as well as the antenna and cable system.
4
WHEN
THE
UNIT
IS PLUGGED
IN
• Never expose the unit to rein or water. DO NOT OPERATE if liquid has
been spilled into the unit. Immediately unplug the unit, and have it
inspected by a service technician. Fire and shock hazards can result from
electrical shorts caused by liquid contact inside.
• Never drop or push any object through openings in the unit. Some internal
parts carry hazardous voltages and contact can cause electric shock or
fire hazard.
* Avoid placing the unit directly above or below your TV set as this may
cause electrical
interference. Keep all magnets away from electronic
equipment.
5 USING
ACCESSORIES
Use only accessories
recommended by the manufacturer
to avoid risk of
fire, shock, or other hazards.
6 CLEANING
THE UNIT
Unplug the unit. Then, use a clean, dry, chemically untreated cloth to gently
remove dust or debris. DO NOT USE cleaning fluids, aerosols, or forced air
that could over-spray, or seep into the unit and cause elect ".ncal shock.
Any substance such as wax, adhesive tape, etc. may mar the cabinet
surface. Exposure to greasy,- humid, or dusty areas may adversely affect
intemal parts.
I
SERVICE
I
1 DO NOT SERVICE THIS PRODUCT YOURSELF
If, after carefully following the detailed operating instructions, this Video
product does not operate properly, do not attempt to open or remove covers,
or make any adjustments not described in the manual. Unplug the unit and
contact a qualified service technician.
2
IF REPLACEMENT
PARTS
ARE
REQUIRED
Make sure the sawica technician uses only parts specified by the ma_acturer,
or those having the same safety characteristics as the original parts. The usa of
unauthorized substitutes may result trine, elac_ic shock, or other hazards.
3
HAVE
THE SERVICE
TECHNICIAN
PERFORM
A SAFETY
CHECK
After any service or repairs to the unit, request the service technician to
conduct a thorough safety check as described in the manufactura's service
literature to insure that the video unit is in safe operating condition.
3

Advertisement

Table of Contents
loading

Table of Contents