Important Safeguards And Precautions; Safety Precautions - Panasonic Omnivision PV-V4620 Operating Instructions Manual

4
Important Safeguards and Precautions
I
|
1
FOR YOUR SAFETY, READ AND
RETAIN ALL SAFETY AND OPERATING
INSTRUCTIONS. HEED ALL WARNINGS
IN THE MANUAL AND ON THE UNIT
INSTALLATION
POWER SOURCE CAUTION
Operate only from a power source indicated on the unit or in
this manual. If necessary, have your Electric Utility Service
Company or Video Products Dealer verify the power source
in your hame.
POLARIZED OR GROUNDING PLUG
As a safety feature, this Video product comes with either
a polarized power cord plug (one blade is wider than the
other), or a three-wire grounding type plug.
POLARIZED PLUG CAUTION:
This plug will only fit into an outlet one way. If you cannot
fully insert the plug, try reversing it. If it still will not fit,
have an electrician install the proper wall outlet.
Do not defeat the safety feature by tampering with the plug.
GROUNDING PLUG CAUTION:
This plug will only fit into a three-hole grounding outlet,
If necessary, have an electrician install the proper outlet.
Do not defeat the safety feature by tampering with the plug.
3
POWER CORD
Make sure power cords are routed so that they are not likely
to have anything rest on them, rolt over them, or be in the
way of walking traffic. If an extension cord is used, make
OUTDOOR ANTENNA INSTALLATION
SAFE ANTENNA AND CABLE CONNECTION
If an outside antenna or cable system
is connected to the equipment, wc
be sura the antenna or cable system
is grounded so as to provide some
protection against built up static
charges and voltage surges.
Section 810 of the Nationa!
Electrical Code, ANSI/NFPA 70
(in Canada, part 1 of the Canadian
Electrical Code) provides information
with respect to proper grounding of the
mast and supporting structure, grounding
of the lead-in wire to an antenna discharge unit,
size of grounding conductors, location of antenna discharge unit, connection
to grounding electrodes and requirements for the grounding electrode.
KEEP ANTENNA CLEAR OF HIGH VOLTAGE POWER LIMES
OR CIRCUITS
An outside antenna system should be located well away from power lines;
electric light or power circuits and where it will never come into contact with
these power sources if it should happen to fall. When installing an outside
antenna, extreme care should be taken to avoid touching power lines,
circuits or other power sources as this could be fatal. Because of the
hazards involved, antenna installation should be left to a professional.
USING THE VIDEO UNIT
ELECTRODE SYSTEM
(REC ART 250, PART H)
If the unit has been in storage or moved to a new location,
refer first to the INSTALLATION section of these safeguards.
; ; : 1 KEEP THIS VIDEO UNIT AWAY FROM WATER OR
: sure it also has either a polarized or grounded plug and that
; the cords can be securely connected. Frayed cords, damaged MOISTURE OF ANY KIND.
pugs. ane ead Wa cuales cores teen derea 2 IF EQUIPMENT IS EXPOSED TO RAIN, MOISTURE, OR
u
echnician.
A
Da
ie
. Overloaded outlets and extension cords are fire hazards and STRONG IMPACT, unplug the unit and have it inspected by a qualified
; should be avoided. service technician before use.
4 DO NOT BLOCK VENTILATION HOLES 7 DURING. AN ELECTRICAL STORM ;
Saat : : A During a lightning storm, whether indoors or outdoors, or before leaving the
-Ventilation openings in the cabinet release heat generated unit unused for extended periods of time, disconnect all equipment from the
during operation. if they are blocked, heat build-up inside the y
unit can cause failures that may result in a fire hazard or power source as well as the antenna and cable system.
heat damage to cassettes. 4 WHEN THE UNIT IS PLUGGED IN
For protection, follow these rules: « Never expose the unit to rain or water. DO NOT OPERATE
a. Never cover ventilation slots or the unit if liquid has been spilled into the unit. Immediately unplug the unit,
while in use, or operate the unit when placed and have it inspected by a service technician. Fire and shock hazards
on a bed, sofa, rug, or other soft surface. can result from electrical shorts caused by liquid contact inside.
b. Avoid built-in installation, such as a book case + Never drop or push any object through openings in the unit. Some intemal parts
or rack, unless proper ventilation is provided. cary na eared aah pr ol pe ct n Fa oan ory a fire hazard.
! * Avoid placing the unit directly above or below your TV set as this may cause
5 SUD! ARIAS CHANGES" OR electrical interference. Keep alt magnets away from electronic equipment, f
Do not place the unit over or near any kind of heater 5 Kana ACCESSORIES ded by th f t id risk of fi
or regulator, in direct sunlight, inside a closed vehicle, etc.. se only accessories recommended by the manufacturer to avoid risk of 'ire,
Do not move the unit suddenly between areas of extreme shock, or other hazards.
temperature variation. If the unit is suddenly moved from a 6 CLEANING THE UNIT
cold place to a warm place, moisture may condense in the
unit and on the tape.
TO AVOID PERSONAL INJURY
* Do not place unsecured equipment on a sloping surface,
* Do not place this unit on any support
that is not firm, level, and adequately
strong. The unit could fall causing
serious injury to a child or adult and
damage to the unit.
* An appliance and cart combination
should be moved with care.
Quick stops, excessiva force, and
uneven surfaces may cause the
appliance and cart combination to overturn,
¢ Carefully follow all operating instructions and use
the manufacturer's recommended accessories when
operating this unit or connecting it to any other equipment,
Safety Precautions
Warning: To prevent fire or shock hazard, do not expose this equipment to rain or moisture.
CAUTION: To prevent electric shock, match wide blade of plug to wide slot, fully insert.
Attention: Pour éviter les chocs électriques, introduire la lame la plus large de la fiche dans la
A CAUTION A
OF LECT
[ DO NOT OPEN ]
TO REDUCE THE RSK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (DA BACK}
NO USER-SERYICEABLE PARTS SIDE
H E F E R SERVICING TO QUALIFIED SERVICE PERSONNEL
Unplug the unit. Then, use a clean, dry, chemically untreated clath to gently
remove dust or debris. DO NOT USE cleaning fluids, aerosols, or forced air
that could over-spray, or seep into the unit and cause electrical shock.
Any substance such as wax, adhesive tape, etc. may mar the cabinet surface.
Exposure to greasy, humid, or dusty areas may adversely affect intemal parts.
SERVICE .
1
DO NOT SERVICE THIS PRODUCT YOURSELF
lf, after carefully following the detaited operating instructions, this Video
product does not operate properly, do not attempt to open or remove
covers, or make any adjustments not described in the manual.
Unplug the unit and contact a qualified service technician,
IF REPLACEMENT PARTS ARE REQUIRED
Make sure the service technician uses only parts specified by the manufacturer,
or those having the same safety characteristics as the original parts. The use of
unauthorized substitutes may result in fire, electric shock, or other hazards.
3 HAVE THE SERVICE TECHNICIAN PERFORM A SAFETY CHECK
After any service or repairs to the unit, request the service technician to
conduct a through safety check as described in the manufacture's service
literature to insure that the video unit is in safe operating condition.
borne correspondante de la prise et pousser jusqu'au fond.
This symbol wams the user that uninsulated voltage within the unit may have sufficient magnitude to cause
electric shock. Therefore, it is dangerous to make any kind of contact with any inside part of this unit,
This symbol alerts the user that important literature conceming the operation and maintenance of this unit
has been included. Therefore, it should be read carefully in order to avoid any problems.
For assistance, call 1-800-211-PANA(7262).