Chuteclean-Outtool - MTD 31AM62EE000 Operator's Manual

Chute Directional Control
CHUTE DIRECTIONAL CONTROL
DISCHARGE
LEFT
Q
ADJUSTABLE
CHUTE TILT
The chute directional control is located on left side of the snow
thrower. To change the direction in which snow is thrown, turn
chute directional control as follows:
Crank clockwise to discharge to the left.
Crank counterclockwise to discharge to the right.
ChuteClean-OutTool
_1 ARI_IING! Never use your hands to clear a
clogged chute assembly. Shut offengine and remain
behind handles until all moving parts have stopped
before unclogging.
The chute clean-out tool is conveniently fastened to the rear of
the auger housing with a mounting clip. Should snow and ice
become lodged in the chute assembly during operation, proceed
as follows to safely clean the chute assembly and chute opening:
1. Release both the Auger Control and the Drive Control.
2. Stop the engine by removing the ignition key.
3. Remove the clean-out tool from the clip which secures it to
the rear of the auger housing.
4. Use the shovel-shaped end of the clean-out tool to
dislodge and scoop any snow and ice which has formed in
and near the chute assembly.
5. Refasten the clean-out tool to the mounting clip on the
rear of the auger housing, reinsert the ignition key and
start the snow thrower's engine.
While standing in the operator's position (behind the snow
thrower), engage the auger control for a few seconds to clear any
remaining snow and ice from the chute assembly.
12 J
SECTION 4 -- CONTROLS AND FEATURES