Dell XPS 730 H2C Service Manual page 24

See the documentation that came with the drive for instructions on installing any software required for drive operation.
13. Enter system setup (see System
Replacing an Optical Drive
1. Follow the procedures in Before You
2. Remove the computer cover (see
3. Remove the drive panel (see
4. Disconnect the power and data cables from the back of the drive.
NOTE: If you are uninstalling your only optical drive and will not replace it at this time, disconnect the data cable from the system board and set it
aside.
1 data cable
5. Slide the drive release latch towards the base of the computer to release the shoulder screw, and then slide the optical drive out of the drive bay.
1 drive release latch
6. To replace the optical drive, prepare the drive for installation and check the documentation that accompanied the drive to verify that the drive is
configured for your computer.
NOTE: If you are installing an IDE drive, configure the drive for the cable select setting.
7. If no screws are attached to the drive, check the inside of the drive panel for screws and, if screws are present, attach the screws to the new drive.
Setup), and select the appropriate Diskette Drive option.
Begin.
Replacing the Computer Cover).
Replacing the Drive Panel).
2 power cable
2 optical drive