Back to Contents Page
Infrared Board
Dell™ Inspiron™ 410 Service Manual
Removing the Infrared Board
Replacing the Infrared Board
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
Removing the Infrared Board
1. Follow the procedures in
Before You
2. Remove the top cover (see
3. Remove the top bracket (see
4. Remove the optical drive (see
5. Remove the drive bay (see
6. Disconnect the infrared cable from the infrared connector on the system board.
7. Lift the release latch and remove the infrared board from the slot on the chassis.
1
infrared cable connector
3
infrared board
Replacing the Infrared Board
1. Follow the procedures in
Before You
2. Replace the infrared board in the slot, and press it in, until it clicks into place.
3. Connect the infrared cable to the infrared connector on the system board (see
Begin.
Removing the Top
Cover).
Removing the Top
Bracket).
Removing the Optical
Drive).
Removing the Drive
Bay).
2
release latch
Begin.
System Board
Components).