Table of Contents
Advertisement
Back to Contents Page
Wireless Mini-Card
Dell™ Inspiron™ 410 Service Manual
Removing the Mini-Card
Replacing the Mini-Card
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
NOTE:
Dell does not guarantee compatibility or provide support for Mini-Cards from sources other than Dell.
If you ordered a wireless Mini-Card with your computer, the card is already installed.
Your computer supports one half Mini-Card slot for Wireless Local Area Network (WLAN).
Removing the Mini-Card
1. Follow the procedures in
Before You
2. Remove the top cover (see
3. Remove the top bracket (see
4. Remove the optical drive (see
5. Remove the drive bay (see
6. Locate the Mini-card (see
System Board
7. Disconnect the antenna cables from the Mini-Card.
1
antenna cables (2)
3
system-board connector
8. Remove the screw that secures the Mini-Card to the system-board connector.
9. Lift the Mini-Card away from the system-board connector.
CAUTION:
When the Mini-Card is not in the computer, store it in protective antistatic packaging (see "Protecting Against Electrostatic Discharge"
in the safety instructions that shipped with your computer).
Begin.
Removing the Top
Cover).
Removing the Top
Bracket).
Removing the Optical
Drive).
Removing the Drive
Bay).
Components).
2
Mini-Card
Hide quick links:
Advertisement
Table of Contents
