Back to Contents Page
Camera Module
Dell™ Inspiron™ One 2305/2310 Service Manual
Removing the Camera Module
Replacing the Camera Module
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
Removing the Camera Module
1. Follow the instructions in
Before You
2. Remove the system board (see
3. Follow the instructions from
4. Turn the display bezel over.
5. Remove the mylar sleeve from the Bluetooth card.
6. Remove the two screws that secure the camera module to the display bezel.
7. Disconnect the camera cable from the connector on the camera module.
8. Lift the camera module off the display bezel.
1
camera cable connector
3
screws (2)
Replacing the Camera Module
1. Follow the instructions in
Before You
2. Align the screw holes on the camera module with the screw holes on the display bezel.
3. Replace the two screws that secure the camera module to the display bezel.
4. Replace the mylar sleeve on the Bluetooth card.
Begin.
Removing the System
Board).
step 5
to
step 11
in
Removing the Display
2
camera module
Begin.
Bezel.