Removing The Rear Stand - Dell Inspiron One 2310 Intel Service Manual

Back to Contents Page
Rear Stand
Dell™ Inspiron™ One 2305/2310 Service Manual
Removing the Rear Stand
Replacing the Rear Stand
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
Removing the Rear Stand
1. Follow the instructions in Before You
2. Remove the back cover (see
3. Follow the instructions from
4. Remove the rear stand cover (see
5. Lift the rear stand and remove the two screws at the bottom of the rear stand hinge.
6. Remove the three screws at the top of the rear stand hinge.
7. Slide the tab on the rear stand hinge out of the slot on the chassis and then lift the rear stand away from the computer.
1 tab
3 screws (5)
Replacing the Rear Stand
1. Follow the instructions in Before You
2. Slide the tab on the rear stand hinge into the slot on the chassis.
3. Replace the three screws at the top of the rear stand hinge.
4. Lift the rear stand and replace the two screws at the bottom of the rear stand hinge.
5. Replace the rear stand cover (see
6. Follow the instructions from
Begin.
Removing the Back Cover).
step 2 to step 5 in Removing the Front

Removing the Rear Stand

Cover).
2 rear stand hinge
4 rear stand
Begin.
Replacing the Rear Stand Cover).
step 4 to step 5 in Replacing the Front
Stand.
Stand.