Inspiron One 2310
6. Wait for approximately five seconds to clear the CMOS setting.
7. Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2 and 3.
8. Replace the system-board shield (see
9. Replace the back cover (see
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
10. Connect your computer and devices to electrical outlets, and turn them on.
Back to Contents Page
Replacing the System-Board
Replacing the Back
Cover).
Shield).