Mitsubishi TS-5057 Owner's Manual page 94

Using the Active A/V Network Feature (cont.)
Important:
using the quick program button (QUICK PROGRAM)
When you press QUICK PROGRAM to be,gin programming your
VCR:
• Active A/V Network will turn on your VCR and bring it to the
"Program to Record" screen. If the VCR's clock has not been set,
you will see the "Set the clock" screen. (See your VCR's Owner's
Guide for information about setting the clock.)
• Active A/V Network will turn on your Projection TV (if it is off),
and switch the Projection TV to i[nput-1.
You can program your VCR by pointing your remote control at the
Projection TV.
When you press QUICK PROGRAM to end programming your
VCR:
• Active A/V Network will turn offyour VCR (unless a tape is
currently playing or recording).
• Active A/V Network will return your Projection TV to the
channel it was on before, or turn i1:oil (if it was off originally).
using the PLAY button (AUTO PI.kY)
When you press PLAY on the remote:
• Active A/V Network will turn your VCR on and b%dn playing
the tape (if any).
• Active A/V Network will turn your Projection TV on and switch
it to Input-1.
When you turn your Projection TV off:
• Your VCR will turn off, unless it is playing or recording.
using the PIP button (TWO TUNER PIP)
You must be watching' a broadcast channel on Antenna-A or
Antenna-B to use the .Active A/V Network PIP function correctly.
When you press the PIP button on the remote to bring up a PIP
image:
• Your VCR will automatically turn on.
• You can see the VCR's picture in the small PIP image.
92
Chapter 4: Using the Special Features