Table of Contents
Advertisement
MENUSECTION MEMORY
The camera can remember which menu section was last opened. If
the menu section memory function is on, when the menu button is
pressed, the last menu section that was last displayed
is opened.
When menu section memory is off, section 1 of the recording or
playback menu is displayed
when the menu button is pressed.
DELETE CONFIRMATION
Each time a delete command
is used a confirmation
screen
appears confirming
the action to erase the image data. When this
screen opens, the no button is highlighted.
This function
allows the
yes button to be initially highlighted to make deleting images
easier. Care should be taken when deleting images as the data
cannot be retrieved once erased.
CLEAN COD
Only clean the CCD when necessary. Improper cleaning may damage the CCD.
Dust can enter the camera body when changing
lenses. The camera should have a lens or body
cap mounted at all times. Confirm the rear of the lens and cap is free from dust before mounting on
the body.
Clean the CCD in a dust-free
environment.
Use a blower brush to remove the dust - compressed
air
can damage the camera.
Accessory
Notes
..,_
I
The optional DiMAGE Master software can remove the affects of dust from RAW images. This
I
is done by taking a dust reference image before cleaning the CCD. For more on the full version
The battery should be fully charged before cleaning the CCD. if
battery power is low, this function
cannot be used. The use of the
optional AC adapter is recommended
over the use of the battery.
Cleaning the CCD without sufficient
power will cause permanent
damage.
Highlight "Enter" and press the center of the controller to begin the
cleaning routine.
Before the CCD is exposed, a confirmation
screen appears;
choosing
"Yes" executes opens the shutter and mirror, "No"
cancels the cleaning operation.
Remove the lens or body cap.
Use a blower brush to clean the CCD. Hold the body so it is
leaning forward to prevent the dust blown from the CCD resettling
in the camera. Do not touch the interior of the camera, if the
camera starts beeping, power is low. Immediately
stop cleaning
and turn the camera off.
Turn the camera off to complete
the operation. Replace the lens or
body cap.
Advertisement
Table of Contents
