Maytag MHWE550WR01 Use & Care Manual page 25

Front-loading automatic washer
Table of Contents

Advertisement

Available languages

Available languages

Washer stops
Check the following:
Is the power
cord plugged
into a grounded
3 prong outlet?
Is there power
at the plug?
Check electrical
source or ca[[ an electrician.
Has a household
fuse blown,
or has a circuit
breaker tripped?
Replace the fuse or reset the
circuit
breaker. If the problem
continues,
ca[[ an electrician.
Are you using an extension
cord?
I)o not use an extension
cord.
Is the detergent
type selector
in the correct position?
Selector should
be on the right for liquid
detergent
and to the left for powdered
detergent.
Washer
odor
See "Cleaning
Your Washer."
Are you using HE detergent?
Use of non-HE
detergent
can cause a film residue which
can result in odor.
Did you leave the door open after use?
This washer
has a tight seal to avoid water
leaks. To avoid odors
leave the door open to
allow the washer
to dry between
uses.
Washer
won't
drain or spin
Is the drain hose kinked? Is the drain hose clogged, or the end of the drain hose more
than 96" (2.4 m) above the floor?
Is your voltage low?
Check electrical source or call electrician. Do not use an extension cord.
Is the "SUD"
routine active?
Cycle
will complete
once extra suds are removed.
Is the load balanced?
A single or bulky
item may cause imbalance.
Add more items or redistribute
the load.
Washer
makes noise or vibrates
Is the washer
level?
The washer
must be level. The four feet should
be properly
installed,
and the nuts should
be tightened
against the washer
cabinet.
As water
is drained
from the washer, you may hear air being pulled through
the pump.
This happens
during
the end of draining.
It is normal
Are you washing
items with
metal snaps, buckles,
or zippers?
You may hear metal items touching
the washer drum. This is normal
Is washer
installed
on a sturdy and solid floor?
Refer to the "Installation
Instructions"
for flooring
requirements.
Noise and vibration
may
be reduced
by securing
a piece of 3/4" (19 mm) plywood
underneath
your washer.
The
plywood
may extend
underneath
both washer
and dryer to keep them
at equal heights.
Washer
leaks
Check
household
plumbing
for leaks.
Are the inlet hose connections
tight?
For inlet hose connections,
see "Connect
the Inlet Hoses."
Dispensers
clogged
or leaking
Are the laundry products in the correct dispenser compartment?
Add the correct
amounts
of detergent,
fabric
softeneb
or liquid
chlorine
bleach
to the
correct
compartments.
Load too wet
Did you use the right
cycle for the load being washed?
Select a cycle with a higher spin speed.
Did you wash a single
item or bulky items or have you overloaded
the washer?
A single item, bulky
items, or overloading
may cause imbalance.
Add items or try to
evenly
distribute
your wet laundry
in the drum,
and start a L-)rain/Spin cycle. If the laundry
is still wet, take haft of the load out of the washer
and try again.
NOTE:
Use of the Max Extract
TM
option
is recommended
for heavy loads.
Residue
or lint on load
Did you add detergent
to the dispenser?
For best results, add detergent
to the Main wash compartment.
I])o not add detergent
to
the washer
drum.
Did you sort properly?
Sort lint givers (towels, chenille) from lint takers (corduroy, synthetics). Also sort by color.
Did you overload
the washer?
I)o not overload
the washer. The washer
can be fully
loaded,
but not tightly
packed.
The wash load must be balanced.
I.int can be trapped
in the load if overloaded.
Check
the following:
Was paper or tissue left in pockets?
Did you use enough HE detergent?
Use enough
detergent
to remove
lint and hold it in suspension.
Use only
H E detergent.
Follow
the manufacturer's
instructions
to determine
the amount
of detergent
to use.
Is your water colder than 60°F (15.6°C)?
Wash water colder
than 60°F (15.6°C)
may not completely
dissolve
the detergent.
Are you using a low speed wash cycle?
Powdered
detergents
may not dissolve
well
in a slow-speed
cycle. For best results, use
liquid
detergent
for slow-speed
cycles such as Delicate
and Handwash.
Stains
on load
Did you add detergent
to the dispenser?
For best results, add detergent
to the Main wash compartment.
[)o not add detergent
to
the washer
drum.
2!:

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents