Setting The Clock And Timer - Maytag CRE9830BCE Owner's Manual

Broil Pad
Use this pad to select broil, Two heat selections are
available for broiling--Hi and Lo. See page 12 for more
broiling information.
Self Clean Pad
Press this pad to set the oven for a self-clean cycle. See
pages 14-15 for detailed information on the self-dean
feature.
Oven Stop/Cook Time Pads
These pads are used to program the oven to start and
stop automatically; either immediately or at a later time.
For detailed information on using Programmed Oven
Operations, see pages 12-!3.
Convect Pad
Press this pad to select convection baking and roasting.
Set the oven temperature by pressing the • or • pads.
See pages 10 I1 for more information on convection
cooking.
Oven Temp Pad
Press this pad to select regular baking and roasting. Set
the oven temperature by pressing the • or • pads.
Additional information can be found on pages i0-11.
Timer Pad
The timer can be set from 1 minute to 9 hours, 50
minutes. It wiI1 count down by seeonds (when set for 1
minute) or minutes (when set for 2 minutes or more
time). See below" for instruetions on setting the timer.
• and • Pads
Press or press and bold these pads to enter the time or
temperature desired. These pads are 'also used to select
Hi or Lo broil.
Setting the Clock and Timer
Clock
To set the time-of-day clock:
1. Press the CLOCK pad once. The words "SET
TIME" will flash in the display.
2. Set the correct time of day using the • and • pads.
• To change the time by one minute, press either
pad once.
• To change the time in increm.ents of i0 minutes,
press and hold either pad.
When the power is first supplied to the range or if there
has been a power failure, the display" will flash. Follow
above instructions to set the eloek. The clock time
cannot be changed when the oven is set for a time eook
or self-clean operation. Cancel the operation to set the
eloek.
Press the CLOCK pad to recall the time of day' when
another function is displayed.
Timer
To set the timer:
1. Press the TIMER pad once. The words "SET
TIMER" will flash in the display.
2. Set the desired time using the • and • pads.
• Press either pad once to change the time by, 1
minute (if the Timer is set for up to 1 hour), 5
minutes (if Timer is set fbr over 1 hour) or 10
minutes (if the Timer is set for over 2 hours).
• Press and hold either pad to change the time in 5
minute or 10 minute increments, depending upon
the time set in the display,.
The TIMER can be set from 1 minute (0HR:01) up to 9
hours and 50 minutes (9 HI1:50).
The timing operation will start automatically. Colons
will flasb in the display to indicate a timing operation.
One long continuous beep will signal the end of the
timing operation and "'End" will briefly appear in the
display', The time of day will automatically reappear in
the display. The TIMER pad does not control the
oven.
To cancel: Press the TIMER pad and hold for 3
seconds. The time of day will reappear after a slight
delay.
PAGE 6