Setting The Clock And Timer - Maytag CRE9800 User Manual

You may also press this pad to recall the current
time of day. For example, if the timer is counting
down in the display, press the CLOCK pad to
return the current time to the display. The timer
will continue to count down and a signal will
sound when the time expires.
Cook Time / Oven Stop Pads
These pads are used to program the oven to start
and stop automatically, either immediately or at a
later time. For detailed information on using Delay
Start, see pages 17-!8.
Self Clean Pad
This pad is pressed to set the oven for a self-clean
cycle. See pages 21-22 for detailed information on
using the self-clean feature.
Broil Pad
Two heat selections are available for broiling
- Hi
and Lo. See page 16 for more broiling information.
Oven Temp Pad
The bake temperature is set by pressing this pad
and the A or • pad. Additional baking information
can be found on pages 11-14.
Setting the Clock and Timer
Clock
To set the time-of-day clock:
1. Press the CLOCK pad once. The words Set
Time wil! flash in the display.
2, Set the correct time of day using the A and •
pads,
• To change the time by one minute, press
either pad once.
• To change the time in increments of 10
minutes, press and hold either pad.
When the power is first supplied to the range or if
there has been a power failure, the display will
flash. Follow above instructions to set the clock.
The clock time cannot be changed when the oven
is set for a cook or self-clean operation. Cancel the
operation to set the clock.
Press the CLOCK pad to recall the time of day when
another function is displayed.
Timer
To set the timer:
1. Press the TIMER pad once. The words Set
Timer will flash in the display.
2. Set the desired time using tile Ak and • pads.
• Press either pad once to change the time by
1 minute (ffthe Timer is set for up to 1 hour),
5 minutes (if the Timer is set for over 1 hour),
or 10 minutes (if the Timer is set for over 2
hours).
• Press and hold either pad to change the time
ill 5 minute or 10 minute increments,
depending upon the time set in the display.
The TIMER can be set from 1 minute (0HR:01) up
to 9 hours and 50 minutes (9 HR:50).
The timing operation will start automatically.
Colons will flash in the display to indicate a timing
operation. One long continuous beep will signal
the end of the timing operation and "End" will
briefly appear in the display. The time of day will
automatically reappear in the display. The TIMER
pad does not control tile oven.
To cancel: Press the TIMER pad and hold for 3
seconds. The time of day will reappear aSter a slight
delay.
PAGE 6