Page 1
INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE ric Installation Manual 3O" WIDE FREE-STANDING RANGE PLEASE KEEP THIS MANUAL FOR FUTURE REFERENCE THE MANUAL IS INTENDED TO ASSIST IN THE INITIAL INSTALLATION AND ADJUSTMENTS OF THE RANGE. & ALTERATION, RESULT CLEARANCE DIMENSIONS For complete information...
Precautions To Avoid Possible Exposure To Excessive Microwave Energy Do not attempt to operate this oven with the door open Do not operate the oven if it is damaged. It i_ since open-door operation can result in harmful particularly important that the oven door close...
25" NORMAL COUNTER COUNTER TOP DEPTH HEIGHT 24" CAB NET DEPTH PROVIDE FOR 120/240 VOLI OUTLET IN THIS AREA. FIGURE 2 Electric Free-Standing Ranges Mobile Homes Locating The Range The installation of a range designed for mobile home Place range where it will be well lighted. Do not set range installation must conform with the Manufactured Home...
Anti-tip Device Installation Instructions Cement or Concrete Construction: WARNING: A risk of range tip-over exists if the appliance Suitable screws for concrete construction can be installed accordance with installation obtained at a hardware store. Drill the required size instructions provided. The proper use of this device hole for the screws obtained into the concrete at the...
Page 5
THE OUTLET !_JST 8£ MOUNTED UPRIGHT & NOT RECESSED kING WtTH BACK AGAINST THEN THE RANGE WILL NOT P_SH THE WALL & NOT RECESSED BACK AGAINST THE WALL, THERAKEWILL .Or P_ t[yTHE OUTLET _dST BE MOUNTED ACKC AGAINST THE WALL, _ARKED OF RANGE BRACKET...
Connecting The Range ELECTRIC SUPPLY The range must be installed in accordance with Local and wire plug-in outlet placed at a convenient point near the National Electric Code (NEC) ANSI/NFPA No. 70-1993 back of the range. The range is then connected to this outlet See rating plate on front of range for total connected kw through an approved service cord (pigtail) fastened securely rating.
Page 7
Remove terminal block access cover from range back. (See 3. Both the white wire and the uninsulated (bare) wire from figure 9). the conduit should connect to the white service wire as shown. The bare wire is the range chassis ground. For service cord (pigtail) use, remove knockout ring from conduit plate.
Page 8
WHITE--_ MAIN TERMINAL CONNECTION BLOCK MIDDLE WIRE OF SERVICE CORD BLACK_ GROUND STRAP CONOU_ T (CONNECTED PLATE _':_1 FACTORY) _TRA I N EL IEF CLAT E _ANGE GR_J_ED T_GH _JT_AL CONDUCT_, T MOUNTED FLUSH TO WALL FIGURE lOB FIGURE 10A NORMAL - 3 WIRE PLUG NORMAL - 3 WIRE CONDUIT MAIN TERMINAL...